Condair Dual 2 manual.pdf

50
perform. [kg/h]
appliance: 100
perform. [kg/h]
act.value: 33
unity anal.entry
25 %
unity anal.entry
25 %
p-pump. int/ext
intern
cond. permeate
7 ‰S
permeate limit
15 ‰S
perform. [kg/h]
valve Y6: 35
perform. [kg/h]
valve Y7: 55
perform. [kg/h]
valve Y8: 75
contr.val.p-pump
95 %
Description of display level parameters
The following description explains the parameters that may be accessed
via the and keys once the display level has been launched (with
the or key).
– Maximum humidification output
Maximum spraying capacity in kg/hr.
– Current humidification output
Current spraying capacity in kg/hr.
Note: The actual spraying capacity may differ from the displayed value
depending on the current spraying pressure.
– Analog input (humidification request)
Current signal value at the analog input in % of the maximum value.
Note: If the internal controller is active the displayed value corresponds
to the current ambient humidity in %rh.
– Booster pump internal/external
This display indicates whether the control unit is configured to work with
an internal or external booster pump.
– Conductance
Current conductance of the permeate in µS.
– Permeate limit
Selected limit value of permeate conductance in µS.
Note: If this value is exceeded in operation, the drain valve (Y5) of the
connector box is opened until the conductance of the permeate drops
below the given limit value again.
– Spraying capacity of spray valve 1
Nominal spraying capacity of open spray valve 1 (Y6) in kg/hr (at a
spraying pressure of approximately 7 bar).
– Spraying capacity of spray valve 2
Nominal spraying capacity of open spray valve 2 (Y7) in kg/hr (at a
spraying pressure of approximately 7 bar).
– Spraying capacity of spray valve 3 (option)
Nominal spraying capacity of open spray valve 3 (Y8) in kg/hr (at a
spraying pressure of approximately 7 bar).
Note: A nominal spraying capacity value of 0 is displayed if the optional
spray valve 3 is not available.
– Starting point of booster pump
Starting point of the booster pump in % of the maximum humidification
request.
Note: This parameter is available only if the control unit is configured to
work with an internal booster pump.