Condair Dual 2 manual.pdf

4.4 Installation of the components of the decentralized system
36
Mounting profiles for direct
fastening to the monobloc
560 mm
260 mm
500 mm
400 mm
Z409
General notes on location and fastening
– Locate the system components so that:
– the distance between particular components is as short as possible
and the maximum admissible distance is not exceeded.
– they are freely accessible, with enough space for operation and maintenance
(0,5 m minimum clearance around the components,
distance to floor at least 1 m).
– The booster pump, the silver ionization unit, and the connector box
must be installed only in a location having a water drain on the floor.
If, for any reason, this is not possible it is mandatory to provide water
sensors to safely interrupt water supply in case of leakage. Furthermore,
install the components in a location that prevents damage to
material assets in case of leakage.
– Danger of damage! Do not install the components in exposed locations
or locations with excessive dust load.
– The booster pump is designed for wall mounting while the control
unit, the silver ionization unit, and the connector box are designed for
direct fastening to the ventilation duct/monoblock. Make sure the
construction (wall, pillar, housing etc.) to which the components are to
be mounted, offers a sufficiently high load-bearing capacity and is suitable
for the installation.
Caution! Do not mount the components to vibrating parts.
– Use only the provided fastening material to mount the various components.
If for some special reasons an installation with the supplied
fastening material is not feasible, choose a type of installation that is
equally stable.