Condair Dual 2 manual.pdf

5.5 Setting up operating parameters
52
intgr.time
15 Min.
perform. limit
100 %
analog signal
0-10 Vdc ( 81%)
error history
07/ 10/ 08/ 07
software version
V6.00
Condair Dual
ready
entry
setup level
entry code
9999
entry code
8999
– Integral time of internal controller
Preset integral time of the internal controller in minutes.
Note: This parameter is available only if the internal controller is
active.
– Output limitation
Preset limit value of output in % of the maximum output capacity.
– Analog signal
Range of the selected analog signal in V or mA, respectively.
Note: The value in brackets is the current value in % of the maximum
signal or the current ambient humidity in %rh, respectively.
– Error history
Numeric codes of the 4 most recent errors (example: “07”: last error,
“10”: second to last error, etc.).
Note: Information on the meaning of error codes is given in chapter 7.
– Software version
Current version of the control unit software.
In the setup level you may adjust various operating parameters to adapt
the Condair Dual Hybrid Humidifier to your particular requirements.
Important! The adjustments made in the setup level immediately exercise
an influence on the operating characteristics of the hybrid humidifier. Therefore,
adjustments must be made only by persons having sufficient knowledge
in the field of humidification and air-conditioning technology and being
familiar with the Condair Dual Hybrid Humidifier.
Accessing the setup level
The Condair Dual is in standard operation mode (the display of the control
unit shows the current operating status).
• Simultaneously press the and keys to access the setup level.
The opposite message is displayed briefly.
You are now prompted to enter the 4-digit access code. The leftmost digit
flashes.
• Enter the access code “8808” as follows:
Change the first digit using the and keys. Confirm your entry
with the key. The next digit starts flashing.
Repeat this step to change the remaining digits.