Condair Dual 2 manual.pdf

4.3 Installation of the central unit
Location of the central unit
– The central unit is designed for wall mounting. Make sure the construction
(wall, pillar, etc.) to which the central unit is to be mounted, offers
a sufficiently high load-bearing capacity and is suitable for the installation.
Caution! Do not mount the central unit to vibrating parts.
– The central unit must be installed only in a location having a water
drain on the floor. If this is not possible, it is mandatory to provide water
sensors to safely interrupt water supply in case of leakage. Furthermore,
choose a suitable location that prevents damage to material
assets in case of leakage.
– Make sure the ambient conditions at the desired location meet the
specifications outlined in chapter 8.2.
– Danger of damage! Do not install the central unit in exposed locations
or locations with heavy dust load. Use the optional casing (option
“Z408”) to protect the central unit from damage and soiling, or use the
central unit with spray circle discharge integrated in two protective cabinets
(option “Z409”).
– Install the central unit so that the water hoses between the connector
box and the nozzles are as short as possible (max. 10 m).
– Install the central unit in a freely accessible location providing enough
space for operation and maintenance (0,5 m minimum clearance
around the central unit, distance to floor at least 1 m).
Installation of the central unit
Use the provided fastening set to mount the central unit to the wall or to the
monobloc. If for some special reasons an installation with the supplied
fastening material is not feasible, choose a type of installation that is equally
stable.
Important! Use a level for accurate horizontal adjustment.
900 mm
640 mm
ø10 mm
ø8x50 mm
Z408
35