Automatic control function programming manual ladder language

Variable Mnemonic
(group 1 to 8)
Description
%Wg00.0 C_AUTAV1 Feed authorisation on group g
to C_AUTAV8 This variable is active if general feed authorisation bit AUTAV = 1.
Reset to stop movement on the axis group in all modes with movements.
Movement is resumed when C_AUTAVg = 1.
%Wg01.7 C_M011 Enable optional programme stop (M01) on group g of independent CNC axes.
to C_M018 A pulse enables or inhibits the optional programme stop by toggling from the
previous state.
%Wg01.6 C_SLASH1 Enable block skip on group g of independent CNC axes.
to C_SLASH8 A pulse enables or inhibits block skip by toggling from the previous state.
%Wg01.4 C_DGURG1 Emergency retraction request for group g.
to C_DGURG8 This request is accepted in AUTO and SINGLE modes. The current block is
interrupted and the system branches to the last emergency retraction programme
declared in the part programme by function G75. If no emergency retraction
programme is specified, this signal is processed in the same way as C_ARUS.
%Wg01.3 C_RAX1 Select axis recall on group g of independent CNC axes.
to C_RAX8 This request is accepted in AUTO, SINGLE and DRYRUN modes.
%Wg01.2 C_CYCLE1 Cycle start request on PLC axis group g or independent group
to C_CYCLE8 Allows execu,ion of the AUTO and SINGLE modes for the PLC axis groups.
A pulse command must be used for C_CYCLEg to prevent resumption of
machining after detection of M02 or a reset in the AUTO mode.
This flag is ignored unless the group is valid.
%Wg01.1 C_ARUS1 Request cycle stop on group g of independent CNC axes.
to C_ARUS8 This request is accepted in AUTO, SINGLE, DRYRUN, SEARCH, TEST and MDI
modes.
%Wg01.0 C_RAZ1 Reset request on PLC axis group g or independent group
to C_RAZ8 Taken into account if there is no movement on the axes. It is during a reset on
a group that flag VALIDg is taken into account and the presence of the part
programme assigned to the PLC group is detected.
3.8.4.2 Feed Rate Potentiometer Setting: %Wg02.B
Variable Mnemonic
(group 1 to 8)
Description
%Wg02.B POTAV1 Feed Rate Potentiometer Setting Required on Group g
to POTAV8 Hexadecimal code corresponding to the ADC input value.
Hexadecimal ADC input Feed rate override
code (function anai(.)) percentage
0x0 0 Volt 0%
0xFF 10 Volt 120%
3.8.4.3 Independent Group Mode: %Wg03.B
Variable Mnemonic
(group 1 to 8)
Description
%Wg03.B MOD-GR1
to MOD-GR8
Mode requested on independent group
3 - 62 en-938846/8