Automatic control function programming manual ladder language

REMARK The programme requested must be present in the CNC memory to be installed as the
active programme. If it is not present, the system cancels the old active programme
and the message «NO ACTIVE PROGRAMME» is displayed on the current programme
page.
3.8.2.11 Handwheel Assignment: %W1A.B to %W1D.B
Variable Mnemonic Description
%W1A.B AFMAN1 Handwheel 1 Assignment
Contains the physical address of the axis to be moved. Refer to the Installation
and Commissioning Manual for assignment of the physical axis addresses.
%W1B.B AFMAN2 Handwheel 2 Assignment
Same as AFMAN1 for handwheel 2.
%W1C.B AFMAN3 Handwheel 3 Assignment
Same as AFMAN1 for handwheel 3.
%W1D.B AFMAN4 Handwheel 4 Assignment
Same as AFMAN1 for handwheel 4.
3 - 44 en-938846/8
! CAUTION
Variables AFMAN1, AFMAN2, AFMAN3 and AFMAN4 must contain the physical address of
a measured axis.
The assignment of the handwheel to an axis must precede manual movement via the
handwheel.
The JOG, JOGPOSn and JOGNEGn commands (with n from 0 to 31) must be enabled for
the axis concerned.
3.8.2.12 Spindle Potentiometer: %W1E.B to %W21.B
Variable Mnemonic Description
%W1E.B POTBR1 Spindle 1 Potentiometer
A hexadecimal valve corresponding to the ADC input.
Hexadecimal ADC input Spindle speed override
code (anai(..) function) percentage
0x0 0 Volts 50%
0xFF 10 Volts 100%
%W1F.B POTBR2 Spindle 2 Potentiometer
Same as POTBR1 for spindle 2.
%W20.B POTBR3 Spindle 3 Potentiometer
Same as OTBR1 for spindle 3.
%W21.B POTBR4 Spindle 4 Potentiometer
Same as OTBR1 for spindle 4.