Automatic control function programming manual ladder language

Variables
3.8.2.19 Backward of Forward Movement in Path 3 - 51
3.8.2.20 Feed Stop per Axis (the bit number
corresponds to the physical address
of the axis): %W3A.L 3 - 51
3.8.2.21 Current Reduction: %WE00.B to
WE1F.B DISC and 1050 3 - 51
3.8.2.22 1050 Servo-Drive Control Word 3 - 52
3.8.3 Inputs from the Axis Groups 3 - 53
3.8.3.1 Group Status: %Rg00.W 3 - 53
3.8.3.2 Current Machining Cycle Number:
%Rg02.B 3 - 54
3.8.3.3 G Function Status: %Rg03.B 3 - 54
3.8.3.4 Encoded M Function Without Response:
%Rg04.W 3 - 55
3.8.3.5 Encoded M Function With Response:
%Rg1E.W 3 - 55
3.8.3.6 Decoded M Functions: %Rg20.L 3 - 56
3.8.3.7 Decoded M Functions (Spindle Status):
%Rg24.W 3 - 58
3.8.3.8 Axis Clamp/Unclamp 3 - 59
3.8.3.9 Tool Number: %Rg7C.L 3 - 59
3.8.4 Outputs to the Axis Groups 3 - 61
3.8.4.1 Group Commands: %Wg00.W 3 - 61
3.8.4.2 Feed Rate Potentiometer Setting:
%Wg02.B 3 - 62
3.8.4.3 Independent Group Mode: %Wg03.B 3 - 62
3.8.5 System Faults and Diagnostic 3 - 63
3.8.5.1 System or Configuration error 3 - 63
3.8.5.2 System Diagnostic 3 - 63
3.8.6 Selecting the Module to Be Animated 3 - 64
3.8.7 Output Card Write Enable: %W900.0 3 - 65
3.8.8 System Fault Management 3 - 65
3.8.9 External Parameters E30xxx,
E40xxx and E42xxx 3 - 65
3.8.9.1 External Parameters E30xxx 3 - 65
3.8.9.2 External Parameters E40xxx 3 - 66
3.8.9.3 Parameters E42xxx 3 - 66
3.8.10 Physical Organisation of %R and %W
Variables 3 - 67
3.9 %S Common Word Variables 3 - 68
3.9.1 Variable Update 3 - 68
3.9.2 Setting up the Common Words 3 - 68
3.9.3 Organisation of %S Common Word
Variables 3 - 69
3.10 %Y Local Variables- Pointers 3 - 70
3.10.1 General 3 - 70
3.10.2 Indirect Addressing - Pointers 3 - 70
3.10.3 Examples of Use of Pointers 3 - 71
en-938846/8 3 - 3
3