Automatic control function programming manual ladder language

Programme %9999.9 must be structured as follows:
%9999.9
N0
N1 $ MESSAGE NUMBER 1
$ REST OF MESSAGE NUMBER 1
N2 $ MESSAGE NUMBER 2
$ REST OF MESSAGE NUMBER 2
$ REST OF MESSAGE NUMBER 2
Nx $ MESSAGE NUMBER X
Where:
- the bloc numbers (N..) correspond to the numbers of the messages to be displayed,
- the messages are preceded by the character $,
- a message line can contain a maximum of 35 characters,
- unnumbered blocks are used for continuation of the messages.
3.8.2.9 Axis Group Selection: %W17.B
Variables
Variable Mnemonic Description
%W17.B SELECGR Axis Group Selection
Assigns all the data relative to one axis group (part programme, programme
variable, etc.) for display. The data entered from the CNC keyboard in MDI mode
is assigned to the axis group selected.
0 Selection of axis group 1
1 Selection of axis group 2
2 Selection of axis group 3
3 Selection of axis group 4
4 Selection of axis group 5
5 Selection of axis group 6
6 Selection of axis group 7
7 Selection of axis group 8
3.8.2.10 Requested Programme Number: %W18.W
REMARK Used only for axis multigroup machine-tools.
Variable Mnemonic Description
%W18.W PROGDEM Requested Programme Number
Used to load the requested programme number as active programme or request
machining in drip feed mode.
The programme number or drip feed machining request is read by the system on
the rising edge of the reset flag C_RAZ = 1.
0 No programme number requested by the automatic
control function.
1 to 0x270F (9999) Programme number specified by the automatic control
function.
-2 (0xFFFE) Machining in drip feed mode requested by the automatic
control function.
en-938846/8 3 - 43
3