Automatic control function programming manual ladder language

3.8.1.10 Other Variables
Variables
Variable Mnemonic Description
%R14.1 E_BAT Battery status
E_BAT = 0 Batteries OK
E_BAT = 1 Replace batteries
%R14.0 SC_USED Screen enabled in PCNC configuration
Variable set to indicate that the screen is used by a user application (transparent
mode inhibited).
Variable reset to indicate that the screen is used by the NUM CNC application
(transparent mode possible).
%R17.B PGVISU Displayed Page Number
This variable is the image of the page displayed on the NC screen:
%R18.B ERRMACH
0x01 «DIR.» directory page
0x03 «PROG.» programme page
0x04 «INFO» information page
0x05 «L/@» programme variable page
0x06 «AXIS» current point page
0x07 TOOLS» tool correction page
0x08 «PROCAM» graphic programming page
0x19 Load page during machining
0x1A Unload page during machining
0x09 «I/O» input/output page
0x0A «UTIL» utility page
0x15 «SHIFT» shift page
0x17 Edit mode page
0x0E Load mode page
0x11 Unload mode page
0x1B Transparent mode called directly by PUTKEY
Machine Error Number
This variable contains the machine error number detected by the system (errors
18, 30-33, 35, 36, 39-71, 210-241, 245, 300-331) as a decimal code.
REMARK Refer to the Operator Manual for the list of machine errors.
%R19.B ID_KB_CN Operator panel or CNC active identifier
In a multipanel configuration, gives the number of the active panel (0 to 7)
In a multi CNC configuration, gives the number of the active CNC (0 to 4)
%R1A.W PROGCOUR Active Programme Number
This variable contains the number of the active programme.
The value 0XFFFF (-1) indicates there is no active programme.
The value 0xFFFE (-2) indicates selection of the drip feed mode.
en-938846/7 3 - 35
3