Automatic control function programming manual ladder language

3.8.1.7 Spindle Status: %R12.W
Variables
Variable Mnemonic Description
%R12.7 B4_ARR Bit set when spindle 4 is stopped, i.e. its rotation speed is less than the setting of
parameter E90343 (see Programming Manual)
%R12.6 B3_ARR Bit set when spindle 3 is stopped, i.e. its rotation speed is less than the setting of
parameter E90342 (see Programming Manual)
%R12.5 B2_ARR Bit set when spindle 2 is stopped, i.e. its rotation speed is less than the setting of
parameter E90341 (see Programming Manual)
%R12.4 B1_ARR Bit set when spindle 1 is stopped, i.e. its rotation speed is less than the setting of
parameter E90340 (see Programming Manual)
%R12.3 B4_ROT Bit set to indicate that the rotation of spindle 4 is correct, i.e. that its rotation
speed is within the speed tolerance interval specified in parameter E90353
(see Programming Manual)
%R12.2 B3_ROT Bit set to indicate that the rotation of spindle 3 is correct, i.e. that its rotation
speed is within the speed tolerance interval specified in parameter E90352
(see Programming Manual)
%R12.1 B2_ROT Bit set to indicate that the rotation of spindle 2 is correct, i.e. that its rotation
speed is within the speed tolerance interval specified in parameter E90351
(see Programming Manual)
%R12.0 B1_ROT Bit set to indicate that the rotation of spindle 1 is correct, i.e. that its rotation
speed is within the speed tolerance interval specified in parameter E90350
(see Programming Manual)
%R13.3 POSBR4 Spindle 4 in position
For a spindle indexing or synchronisation request, indicates that spindle 4 is in
position or synchronised.
Set when the required position is reached.
Reset after leaving the required position, by oscillations and by cancellation of
function M19.
%R13.2 POSBR3 Spindle 3 in position
For a spindle indexing or synchronisation request, indicates that spindle 3 is in
position or synchronised.
Set when the required position is reached.
Reset after leaving the required position, by oscillations and by cancellation of
function M19.
%R13.1 POSBR2 Spindle 2 in position
For a spindle indexing or synchronisation request, indicates that spindle 2 is in
position or synchronised.
Set when the required position is reached.
Reset after leaving the required position, by oscillations and by cancellation of
function M19.
%R13.0 POSBR1 Spindle 1 in position
For a spindle indexing or synchronisation request, indicates that spindle 1 is in
position or synchronised.
Set when the required position is reached.
Reset after leaving the required position, by oscillations and by cancellation of
function M19.
en-938846/6 3 - 33
3