Automatic control function programming manual ladder language

Variable Mnemonic Description
%R3.3 E_RAX General axis recall
In CYHLD mode and at the end of SEARCH, indicates axis recall is enabled.
Set by read of C_RAX = 1 by the NC.
Reset by read of C_RAX = 0 by the NC.
%R3.2 E_CYCLE Cycle in progress
Set by the CYCLE key on the machine panel (C_CYCLE = 1).
Reset by the RAZ key on the panel, C_RAZ = 1 or at the end of execution of the
programme (M02).
%R3.1 E_ARUS Cycle stop
Indicates the CYHLD state of the system (programme stopped during execution
and enabling of axis jogs).
Set by the CYHLD key on the machine operator panel (C_ARUS = 1).
Reset by the CYCLE key on the machine operator panel (C_CYCLE = 0).
%R3.0 E_RAZ CNC reset in progress
Pulse bit with a duration of 100 ms indicating a system reset.
While this pulse is high, data from the automatic control function are ignored.
Set by the RAZ key on the panel, a reset request from the automatic control
function (C_RAZ = 1), at the end of execution of a part programme (M02) or when
the NC is turned on.
This variable is reset after 100 ms.
3.8.1.3 CNC Status: %R4.W
Variable Mnemonic Description
%R5.7 E_TRANSP Transparent mode
Gives access by the machine processor to the CNC operator panel for display of
data (data tables, etc.). Machining may be in progress.
Set by enabling the «TRANSPARENT MODE» screen page.
Reset by clearing the «TRANSPARENT MODE» screen page.
%R5.5 E_PPP Drip feed mode ready
Indicates that the NC is ready to operate in drip feed mode or that the machining
ordered by the automatic control function will be carried out in drip feed mode. In
the second case, PROGDEM must be initialised with -2 (0xFFFE).
Set after «CHOICE OF CURRENT PROGRAMME» and keyboard entry of PPR
or PPL followed by ENTER.
Reset after «CHOICE OF CURRENT PROGRAMME» and keyboard entry of -
PPR or -PPL followed by ENTER.
%R5.1 E_PROG Active programme
Indicates that a part programme is being executed in AUTO, SINGLE, MDI or
DRYRUN mode.
Set by the first action on the CYCLE key on the machine operator panel
(C_CYCLE = 1).
Reset by detection of M00 (programme stop), M01 (optional stop), M02 (end of
programme); the RAZ key on the operator panel, variable C_RAZ = 1 and at
power on.
3 - 30 en-938846/6