Automatic control function programming manual ladder language

3.8.7 Output Card Write Enable: %W900.0
Variables
Variable Mnemonic Description
%W900.0 INIB_E33 Write of output cards by part programme enabled.
Variables %Qrc3B.1 must already be programmed in %INI.
Set to inhibit write of variables %Qrc in a part programme by parameters E33xxx
or by dynamic operators.
Reset to enable write.
3.8.8 System Fault Management
The following variables control actions of the monitor when system or configuration faults are detected.
The system fault management variables will be covered later.
3.8.9 External Parameters E30xxx, E40xxx and E42xxx
! CAUTION
Parameters E30xxx and E40xxx are not saved. They are reset at power on.
3.8.9.1 External Parameters E30xxx
Parameters E42xxx are saved.
128 words x 32 bits are addressed by E30000 to E30127.
Parameters E300xx are written by the part programme. They contain significant signed numerical values. They can
be read from and written to by the user programme.
Mnemonic MSB LSB
E30000 %RA00 %RA01 %RA02 %RA03
to
E30031 %RA7C %RA7D %RA7E %RA7F
E30032 %RB00 %RB01 %RB02 %RB03
to
E30063 %RB7C %RB7D %RB7E %RB7F
E30064 %RC00 %RC01 %RC02 %RC03
to
E30095 %RC7C %RC7D %RC7E %RC7F
E30096 %RD00 %RD01 %RD02 %RD03
to
E30127 %RD7C %RD7D %RD7E %RD7F
en-938846/8 3 - 65
3