Automatic control function programming manual ladder language

Variable Mnemonic Description
%W5.6 SK_DISPL Softkey bar window display
Set to inhibit display of the softkey bar window.
Reset to enable display of the softkey bar window.
REMARK Inhibiting of the display does not inhibit use of the softkeys.
%W5.5 INIBCLAV Keyboard inhibit
Set to inhibit the alphanumeric QWERTY keyboard and function keys for the
basic softkeys which are then no longer processed by the CNC.
The key codes are however transmitted to the automatic control function by
CARCLAV.
%W5.4 IMPULS Operator panel pulse inputs
Disable the RAZ, ARUS, CYCLE, M01, / keys and the TCOMP softkey.
Set to disable the keys on the CNC operator panel and enable selection by the
automatic control function.
%W5.3 CORDYN Wear offset load enable
Set to enable load of the wear offsets by the automatic control function and
disable load from the operator panel.
%W5.2 JOGPUP JOG selection from the operator panel
Set to disable selection of the jog type by the CNC operator panel and enable
selection by the automatic control function.
%W5.1 MODEPUP Operator panel mode selection
Set to disable mode selection by the CNC operator panel and enable mode
selection by the automatic control function.
The mode is selected by the PLC. The mode number is encoded in %Wg03.b.
The mode codes are the same as those of %W14.b for common modes.
%W5.1=0. Except for MMI, the modes can be selected from the operator panel.
The mode is assigned to the group selected by %W17.b.
%W5.0 PUPABS CNC panel absent
Set to declare the CNC panel absent.
All the CNC operator panel functions are disabled and can be simulated by the
automatic control function.
3.8.2.3 Positive JOG Commands: %W6.L
Variable Mnemonic Description
%W6.7 JOGPOS31 Positive jog on axis No. 31
to %W6.0 to JOGPOS24 to Positive jog on axis No. 24
%W7.7 JOGPOS23 Positive jog on axis No. 23
to %W7.0 to JOGPOS16 to Positive jog on axis No. 16
%W8.7 JOGPOS15 Positive jog on axis No. 15
to %W8.0 to JOGPOS8 to Positive jog on axis No. 8
%W9.7 JOGPOS7 Positive jog on axis No. 7
to %W9.0 to JOGPOS0 to Positive jog on axis No. 0
3 - 40 en-938846/8