Automatic control function programming manual ladder language

Variable Mnemonic
(group 1 to 8)
Description
%Rg01.1 E_ARUS1 Exit from cycle stop on group g of independent CNC axes
to E_ARUS8 Indicates system intervention status (programme stopped during execution and
axis jogs enabled).
%Rg01.0 E_RAZ1 Reset in progress on group g
to E_RAZ8 Pulse bit with a duration of 100 ms that indicates a reset on the group.
While this pulse is set, the data from the automatic control function are ignored.
Set by the RAZ key on the operator panel, by a reset request from the automatic
control function C_RAZg = 1, at the end of execution of a part programme (M02)
or at CNC power on.
This variable is reset after 100 ms.
%Rg06.B MODCOUR1 Current mode on CNC independent axis group g.
to The value of this variable is the image of the current CNC mode on independent
MODCOUR8 CNC axis group g.
3.8.3.2 Current Machining Cycle Number: %Rg02.B
Variable Mnemonic
(group 1 to 8)
Description
%Rg02.B NUMCYC1 Current machining cycle number on group g.
to NUMCYC8 Used to read the machining cycle subroutine number from %10000 to %10255
(0 for %10000 to 0xFF for %10255).
3.8.3.3 G Function Status: %Rg03.B
Variable Mnemonic
(group 1 to 8)
Description
%Rg03.1 FILET1 Thread cutting on group g
to FILET8 Indicates execution of a thread cutting cycle: G31 (thread chasing), G33 (thread
cutting) or G38 (sequenced thread cutting), G84K (rigid tapping).
Set by execution of function G31, G33, G38 or G84.
Reset by cancellation of the function.
%Rg03.0 RAPID1 Rapid positioning (G00) on group g
to RAPID8 Indicates execution of G0 in the current block of the part programme.
Set by execution of function G0.
Reset by cancellation of function G0.
3 - 54 en-938846/8