FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
MESSAGES FROM FDR, DSF, AND ABR (FDRNNN) 100.3
Action:
6 – Other I/O error during positioning.
An U0659 ABEND follows. This may be due to hardware problems with the tape drive. If
it occurs with the same input tape on more than one tape drive, contact INNOVATION
DATA PROCESSING for assistance.
FDR605 COPY TERMINATED AT TAPE MARK SEQUENCE
Reason: During a COPY with ALLFILES or MAXFILES=, FDRTCOPY found two consecutive
tape marks following the trailer labels of the last file processed, indicating the end of
the input tape(s).
Action: None. This is a normal completion.
FDR606 COPY TERMINATED BY FILE COUNT
Reason: During a multi-file COPY, FDRTCOPY completed copying the number of files specified
by the MAXFILES= operand.
Action: None. This is a normal completion.
FDR607 COPY TERMINATED BY END OF VOLUME LABELS
Reason: During a COPY with ALLFILES or MAXFILES=, FDRTCOPY detected that the last file
copied was followed by EOV (End-Of-Volume) labels rather than EOF (End-Of-File)
labels, so FDRTCOPY is not able to continue. This probably means that the last file
copied is not complete, which results in an FDR203 message.
Action: None. This is not an error condition unless an FDR203 message is also printed to
indicate that the last file copied was not a complete FDR backup.
FDR609 CURRENT PAGEWIDTH(nnn) EXCEEDED BY vvv--action
Reason: An FDREPORT step specified PAGEWIDTH=nnn but the total length of the fields
requested to be printed exceeds this value. If the output report DDname is not
SYSPRINT, the output DCB is opened with a LRECL that corresponds to the page
width. The result is truncation of the print line and the action is “PRINT LINE
TRUNCATED”. If the report DDname is SYSPRINT, “PRINT LINE TRUNCATED”
appears only if the actual LRECL of 121 is exceeded.
Action: Increase the PAGEWIDTH, specify the AUTOSTACK operand to force eligible field
stacking, or reduce the number of fields to be printed.
FDR610
Reason:
Action:
ICF CLUSTER TABLE FULL--ENTRY COUNT IS nnnnn--ICF SELECTION IS
TERMINATED
Selection of VSAM data sets is being performed by base cluster name utilizing a
look-aside table of clusters. The table has been filled, and selection of additional
VSAM data sets is no longer performed.
See message FDR670.
FDR615 dddddddd DSN=dsname FILE=fn VOL=vvvvvv status
Reason: Printed by FDRTCOPY at the end of each file copied. One FDR615 message is printed
for TAPEIN, TAPEOUT, and TAPE2OUT (if present). It documents the input or output
DDname, data set name, file number (0 if on disk), and up to 20 volume serials.
“status” is DROP if an input file was not copied due to being expired, or CATLG if an
output file was successfully cataloged.
CHAPTER 100 – PAGE 100-104 –