FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
MESSAGES FROM SAR (FDR9NN) 100.4
Action:
NOT LABELED – For an unlabeled tape.
For an output tape, “type” is SL or NL and the expiration date from the tape labels is
displayed “yyddd”. The operator must decide if this tape can be safely used for output.
For an input tape, only the first line of the message is displayed and no reply is
necessary; it simply documents the tape volumes used for input.
Reply “YES” for SAR to use the tape for output. If you reply, “NO”, SAR dismounts the
tape and request a new tape be mounted.
FDR934 REPLY WITH NEW TAPE DATA SET NAME
Reason: SAR is requesting the data set name to be used on a labeled output tape. SAR displays
the name found on the tape (last 17 characters). This message is issued for the first
output tape mounted.
Action: If you simply press ENTER, SAR uses the original data set name. You can override this
name by specifying a new data set name. Up to 44 characters may be specified. If the
NEWNAME is shorter than the original name, the remainder must be blanked out with
the space bar (the ERASE EOF key must not be used). SAR uses the last 17
characters of the name you specify for all output tapes used in this backup.
FDR935 ERROR READING THE VTOC ON DISK REASON=n JOB TERMINATED
Reason: SAR encountered an error reading the VTOC on disk during a backup operation.
1 – I/O error occurred reading the disk volume label. This may be due to an
un-initialized volume.
2 – A logical or hardware error was detected in the VTOC. A FDR951-FDR990
message may have been displayed detailing the error.
3 – First record in the VTOC is not a Format 4.
4 – More than one Format 4 record encountered in the VTOC.
5 – An empty VTOC track was found.
6 – The VTOC track did not deblock. The records found were not a multiple of
140 bytes.
7 – A dummy VTOC on cylinder 0 track 0 was encountered. This usually
indicates a volume initialized for VM.
Action: If JOB TERMINATED does not appear, SAR continues the dump operation, dumping all
of the tracks on the volume.
FDR936 DISK NOT SUPPORTED FOR DUMP - JOB TERMINATED
Reason: SAR cannot dump the volume specified. SAR uses the read multiple count-key-data
CCW that is not supported on this control unit.
Action: Should not occur except on old disk hardware.
FDR937
Reason:
Action:
COMPRESSION TECHNIQUE NOT SUPPORTED
SAR detected that the tape to be restored was compressed in a format that this level of SAR does
not support. The tape was created by a higher release of FDR than the release of SAR.
This tape must be restored by a release of SAR that is compatible with the release of
FDR that created the tape; or the tape can be restored by a high-enough release of
FDR under an operating system, or the tape can be copied to un-compressed format
with a high-enough release of FDRTCOPY under an operating system.
FDR938 PRESS ENTER ON CONSOLE TO RESTART
Reason: SAR has terminated and can be restarted without an IPL by pressing the ENTER key on
the SAR console (EOB on printer/keyboard consoles).
CHAPTER 100 – PAGE 100-120 –