FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
MESSAGES FROM FDR, DSF, AND ABR (FDRNNN) 100.3
FDR376 MULTIPLE ABR MODELS FOUND ON BACKUP DSN=dsname
Reason: FDR found more than one ABR Model DSCB on the backup tape during a full-volume
restore. The first one encountered is the one used. The disk volume serial number or
the ABR Model DSCB name may have been changed prior to the dump without using
the ABR maintenance programs.
Action: SCRATCH the incorrect model using IEHPROGM specifying PURGE on the SCRATCH
command. Use program FDRABRM with a REMODEL command (see Section 50.44
“FDRABRM REMODEL Statement”) or the ABR ISPF dialogs (see Section 90.15 “ABR
Options”) to reset the remaining ABR Model DSCB to the correct Generation and
Cycle number. Contact INNOVATION DATA PROCESSING for assistance.
FDR377 DISK PACK HAS BEEN RELABELED TO VOL=vvvvvv
Reason: Information message indicating that the volume serial of the disk being restored to has
changed by a full-volume restore.
Action: If disk is shared by multiple systems, it should be varied offline and remounted to the
other systems.
FDR378 RENAME FAILED COMP=cccc CODE=code FROMDSN=tempname NEWDSN=permname
CLUSTER=clusname
Reason: On an FDRCOPY MOVE or RESTORE of a VSAM cluster to the same name, the output
cluster and its components were initially created with temporary names (an index level
starting with T is inserted). After the input data set was deleted, FDRCOPY attempted to
ALTER the temporary names back to the original cluster and component names but an
error occurred. “cccc” is the return code and “code” is the reason code from ALTER; look
up these codes under IBM message IDC3009I in the IBM message manuals.
If “cccc” is 04nn, then “nn” is the return code from a RENAME SVC; if it is 05nn, then it
is a return code from the SMS RENAME service.
“tempname” is the temporary cluster or component name that FDRCOPY was trying to
rename back to “permname”. “clusname” is the original name of the cluster if the
rename failed on a component.
Action: If an FDR378 is not issued for the cluster itself, it was renamed successfully and the
cluster can be used under its original name.
If an FDR378 was issued for the cluster, the cluster was not renamed. It can be used
under its temporary name “tempname”, but you probably want to check the error
codes and ALTER the cluster to its original name if possible.
If FDR378 messages were issued for one or more components, those components were
not renamed. The cluster is usable, but you may want to check the error codes and
ALTER the component to its original name if possible.
If needed, contact INNOVATION DATA PROCESSING for assistance.
FDR390 DSF NO DATA SETS MET SELECTION CRITERIA
Reason: No data sets were selected from the current disk volume. For an ABR step, this means
that neither SELECT statements nor ABR automatic criteria (e.g., the update flag for
Volume Backup) selected data sets on this volume.
Action: This may be normal if there were simply no data sets that met ABR requirements on the
volume at this time. Otherwise check your SELECT statements and correct any errors.
FDR391 OPERATOR REPLIED NO TO ARCHIVE ON UNEXPIRED DSN=dsname
Reason: ABR selected a data set for Archive Backup or Superscratch whose expiration date has
not been reached. The operator replied “NO” to the FDRW23 message.
Action: The data set is bypassed. If the EXPD=NONE operand is specified on the DUMP
statement, ABR does not perform this check.
CHAPTER 100 – PAGE 100-79 –