FDR V54L78 - Innovation Data Processing
FDR V54L78 - Innovation Data Processing
FDR V54L78 - Innovation Data Processing
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MESSAGES AND CODES<br />
ABEND CODES 100.8<br />
100.8 ABEND CODES<br />
Any of the programs and utilities in the <strong>FDR</strong> family may ABEND (abnormally end) with any of<br />
the following user ABEND codes. In many cases, a diagnostic message is printed before the<br />
ABEND, so look up any error messages that were printed first. If no message was printed that<br />
relates to this ABEND, then read the explanation below. Call INNOVATION DATA<br />
PROCESSING if you need assistance understanding or resolving the error.<br />
U0100 OPEN ERROR TRYING TO OPEN A DASD OR TAPE DCB<br />
Reason: Usually proceeded by an <strong>FDR</strong>324 message. Check the job log for IBM messages that<br />
may indicate the reason for the error.<br />
U0101 MAXIMUM I/O ERRORS EXCEEDED ON A DIRECT-ACCESS DEVICE<br />
Reason: More disk I/O errors than are allowed by the MAXERR= operand occurred. If you want<br />
to complete the operation in spite of the errors, specify a larger MAXERR= value.<br />
However, many data sets may be invalid.<br />
U0102 ALTERNATE TRACKS INVALIDLY ASSIGNED<br />
Reason: Alternate tracks are not assigned according to IBM specifications. Can only occur during<br />
a dump without BUFNO=MAX.<br />
U0103 DISK DEVICE TYPE NOT SUPPORTED OR VTOC TOO BIG<br />
Reason: The type of disk being backed up or restored is not among those supported by <strong>FDR</strong>, or<br />
for ABR, an internal table was exceeded because the VTOC is too large.<br />
U0104 FULL-VOLUME RESTORE TO UNLIKE DISK DEVICE NOT SUPPORTED<br />
Reason: Use <strong>FDR</strong>DSF, <strong>FDR</strong>COPY, or <strong>FDR</strong>ABR data set restore to restore to an unlike device.<br />
U0110 INVALID EXTENT DESCRIPTOR IN DSCB OR VVDS<br />
Reason: The descriptor for an extent of a data set in the DSCB or in the VVDS was invalid<br />
because it pointed to tracks outside the limits of the volume<br />
U0200 I/O ERROR ON BACKUP DATA SET<br />
Reason: A permanent I/O has occurred on the backup tape or disk data set. The backup is not<br />
usable. This can also occur if a RDJFCB, DEVTYPE, or OPEN fails.<br />
U0201 PREMATURE END-OF-FILE ON INPUT<br />
Reason: The end of the backup file was encountered without finding the special <strong>FDR</strong> trailer<br />
record.<br />
U0202 INVALID BLOCK READ<br />
Reason: An invalidly formatted block was read from a backup.<br />
U0204 INVALID BLOCK READ<br />
Reason: An invalidly formatted block was read from a backup.<br />
U0205 NOT AN <strong>FDR</strong> BACKUP<br />
Reason: A restore process detected that the backup was not created by <strong>FDR</strong>.<br />
U0207 MAXIMUM TAPE BLOCK LENGTH CHECKS EXCEEDED<br />
Reason: See message <strong>FDR</strong>204.<br />
CHAPTER 100 – PAGE 100-163 –
Change language