FDR V54L78 - Innovation Data Processing

More documents

Recommendations

Info

MESSAGES AND CODES COMPAKTOR MESSAGES (CPKNNNXX) 100.6 CPK587W VOL=vvvvvv RECOVERY BYPASSED DUE TO reason Reason: A Fast COMPAKTion (CPK TYPE=FASTCPK) run on disk volume “vvvvvv” (see message CPK586W) did not complete. This Fast COMPAKTion job attempted to recover from the failure but the recovery was unsuccessful for the reason indicated. Action: The volume is not in a usable state. Many data sets may be unusable. Contact INNOVATION DATA PROCESSING if you cannot correct the error. CPK595E Reason: Action: program TERMINATED ABNORMALLY WITH COMP CODE Ssss Uuuuu A COMPAKTOR subtask abnormally terminated with either a system ABEND code “sss” (in HEX), or a user ABEND code “uuuu” (in decimal). “program” is FDR for an FDR full-volume backup (DUMP=YES) or FDRRESTR for the actual modification of the volume. For SYSTEM ABENDs, refer to the appropriate IBM System Codes Manual. For user ABENDs, look it up in Section 100.8 “ABEND Codes”. If the module is FDR, no changes were made to the volume, but if it is FDRRESTR and message CPK321I was printed without CPK403E the volume may be unusable. If possible, correct the error and rerun. Contact INNOVATION DATA PROCESSING for assistance. CPK600In COMPAKTOR status type RUN -- VOL=vvvvvv Reason: Informs you of the status of the run. “type” is the type of run: MAPPING, SIMULATION, RELEASE, or COMPAKTION. “status” is SUCCESSFULLY COMPLETED or COMPLETED WITH ERRORS; in the latter case, some warning messages were issued but the COMPAKTion was able to complete. “n” is an internal code indicating the volume reorganization algorithm was used to position the data sets. CPK601I RESTORED DEVICE IS UNIT=uuuu,VOLSER=vvvvvv,DEVTYPE=ddddddd Reason: Identifies the COMPAKTed volume if an output disk was modified. CPK602A SERIOUS ERROR(S) DETECTED. COMPAKTOR ABENDING Reason: One or more previous error messages were issued and COMPAKTOR terminates abnormally. Action: See the Action for the other error messages. CPK603A COMPAKTOR RESTORE CANCELLED reason Reason: The COMPAKTion of the current volume was bypassed because: SYSTEM RESIDENCE VOLUME – You cannot COMPAKT the current SYSRES (IPL volume). BY CONSOLE OPERATOR – The operator replied “NO” to the FDRW80 WTOR message. CPK604W Reason: COMPAKTOR OPERATION TERMINATED BY CANCEL COMMAND -- REMAINING VOLUMES BYPASSED The operator attempted to cancel the COMPAKTOR job and it was intercepted by COMPAKTOR CANCEL protection. The operator then replied “S” to the FDRW99 message, causing COMPAKTOR to terminate after completing processing on the current volume. If more volumes were to be processed in the step, they are bypassed. CPK605W COMPAKTOR ABENDING DUE TO EXCEEDING MAXIO Reason: COMPAKTOR terminates due to exceeding MAXIO. CPK606E SNAPSHOT REQUEST ERROR - reason Reason: FAST COMPAKTOR was executed with SNAPSHOT=YES, but an error occurred while using SnapShot on an IBM RVA or Oracle StorageTek disk. “reason” details the error. Action: Contact INNOVATION DATA PROCESSING Technical Support. CHAPTER 100 – PAGE 100-142 –
MESSAGES AND CODES COMPAKTOR MESSAGES (CPKNNNXX) 100.6 CPK607E SENSE ERROR - UNKNOWN DEVICE OR DEVICE NOT ECAM CAPABLE SENSE= Reason: FAST COMPAKTOR was executed with SNAPSHOT=YES, but the current installed microcode does not support the ECAM commands required for SnapShot, probably because it was not an IBM RVA or Oracle StorageTek disk subsystem. This message is just informational; it is not normally printed unless a debugging option is enabled. Action: The volume is COMPAKTed with normal READ and WRITE CCWs. CPK608E DWASET TABLE EXHAUSTED Reason: FAST COMPAKTOR was executed with SNAPSHOT=YES, but an internal table overflowed while using SnapShot on an IBM RVA or Oracle StorageTek disk. Action: Contact INNOVATION DATA PROCESSING Technical Support. CPK609E EMC COPY REQUEST ERROR - reason Reason: The “reason” value can be either “MICROCODE LEVEL NOT HIGH ENOUGH” or “CONTROLLER DOES NOT SUPPORT EMCCOPY”. FAST COMPAKTOR was executed with EMCCOPY=YES, but the microcode level of the EMC Symmetrix specified was not high enough to support the internal EMC COPY function or the controller does not support the EMCCOPY instructions. Action: Contact EMC to upgrade your Symmetrix microcode or contact INNOVATION DATA PROCESSING Technical Support. CHAPTER 100 – PAGE 100-143 –
Page 1 and 2:
MESSAGES AND CODES INTRODUCTION TO
Page 3 and 4:
MESSAGES AND CODES FDR CONSOLE MESS
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
MESSAGES AND CODES MESSAGES FROM FD
Page 19 and 20:
FDR020 Reason: Action: MESSAGES AND
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
MESSAGES AND CODES CHAPTER 100 - PA
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92: MESSAGES AND CODES MESSAGES FROM FD
Page 95 and 96: MESSAGES AND CODES CHAPTER 100 - PA
Page 99 and 100: FDR547 Reason: Action: MESSAGES AND
Page 121 and 122: FDR939 Reason: MESSAGES AND CODES T
Page 123 and 124: MESSAGES AND CODES MESSAGES FROM SA
Page 125 and 126: 100.6 COMPAKTOR MESSAGES (CPKNNNXX)
Page 127 and 128: CHAPTER 100 - PAGE 100-127 - MESSAG
Page 129 and 130: MESSAGES AND CODES COMPAKTOR MESSAG
Page 135 and 136: CPK526E MESSAGES AND CODES COMPAKTO
Page 141: MESSAGES AND CODES COMPAKTOR MESSAG
Page 145 and 146: MESSAGES AND CODES FDRREORG MESSAGE
Page 163 and 164: MESSAGES AND CODES ABEND CODES 100.
Page 169 and 170: 100.9 WAIT STATE CODES FROM SAR WAI
show all

FDR V54L78 - Innovation Data Processing

Create successful ePaper yourself

Delete template?

Save as template?