FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
ABEND CODES 100.8
U0210
INTERNAL ERROR IN FDR SOFTWARE COMPRESSION
U0300 MAXIMUM FOR COUNT FIELD ERRORS ON DIRECT-ACCESS DEVICE EXCEEDED
Reason: More FDR123 messages than are allowed by the MAXERR= operand occurred. If you
want to complete the operation in spite of the errors, specify a larger MAXERR=
value. However, many data sets may be invalid.
U0301
MAXIMUM FOR INVALID RECORD ZEROES ON A DIRECT-ACCESS DEVICE
EXCEEDED
U0302 INTERNAL END-OF-EXTENT ERROR
Reason: The IGG019YZ module did not have the FDR identifier or was copied from a previous
version of FDR or ABR. The most likely cause is that although you have installed a
new version of FDR or ABR correctly in a Linklist library, there is an older version of
IGG019YZ in LPALIB or in a library earlier in the Linklist concatenation. You must
SCRATCH the older version.
U0303 ABR FULL-VOLUME RESTORE CANCELLED, NO VTOC ON THE BACKUP
Reason: Message FDR368 was issued.
U0304 INTERNAL ERROR ON FULL VOLUME ABR RESTORE ON MODEL DSCB
Reason: Message FDR374 was issued.
U0305 INVALID ABR RESTORE ALLOCATION LIST
Reason: The ABR Restore Allocation List (FDRALLOC) or one of the ABR Protect Lists
(FDRPROTA, FDRPROTD, FDRPROTR, or FDRPROTS) have been corrupted. The
first 8 bytes of these modules must be the name of the module.
U0401 SYSIN DD STATEMENT ERROR
Reason: A SYSIN DD statement is missing or incorrectly specified or an I/O error occurred on the
SYSIN data set.
U0402 SYSPRINT/SYSPRINn/ABRMAP/SYSMAP DD STATEMENT ERROR
Reason: One of the above DD statements is missing or incorrectly coded or I/O error occurred
processing the data set. There must always be a SYSPRINT DD statement, and there
must be a SYSPRINn DD statement for each backup TAPEn DD statement when
using ATTACH or ABR.
U0405 INVALID PARM FIELD SPECIFIED FOR FDR
Reason: This ABEND indicates that the FDRECALL program did not receive a valid PARM. This
usually occurs when the SYNRECAL PROC is modified and the “PARM='&PTR”
operand is omitted from the SYNRECAL PROC.
U0409
Reason:
IN FDRTSEL, THE NUMBER OF BACKUP FILES SELECTED HAS CAUSED AN
INTERNAL TABLE TO BE EXCEEDED.
You can reduce the number of backup files selected, or you can increase the table size
by specifying TBSIZE=n on the CATLG statement, where “n” is the number of
megabytes (2 to 6) to be obtained for the table (default is 2MB).
U0502 ONE OR MORE CONTROL STATEMENTS ARE IN ERROR
Reason: One or more of the control statements specified are not recognized by the program
being executed.
CHAPTER 100 – PAGE 100-164 –