FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
MESSAGES FROM FDR, DSF, AND ABR (FDRNNN) 100.3
FDR405 MAXIMUM CONTINUATION COUNT OF nnnn EXCEEDED -- COMMAND FLUSHED
Reason: One control statement used too many continuation statements.
Action:
Combine multiple operands onto one line to reduce the number of continuation statements.
FDR406 CONFLICTING OPERANDS - operands
Reason: The operands listed conflict with each other and are mutually exclusive. This message is
normally followed by FDR407.
Action: Refer to the documentation in this manual for the program you are executing. Eliminate
the conflict by removing one or more operands.
FDR407 type ERROR -- action
Reason: An error was encountered during the processing of user supplied control statements.
Always proceeded by one or more messages that define and delimit the error(s).
“type” is either PARAMETER FIELD or CONTROL STATEMENT.
The “action” is one of the following:
JOB TERMINATED – Processing stops after the first error has been encountered.
SKIPPING FOR COMMAND – Processing continues for all command statements
found within the SYSIN data set.
RE-ENTER COMMAND OR END – Message for a user that has SYSIN data set
assigned to a TSO terminal. Re-enter command in error or “END” to
complete the processing.
Action: Correct and resubmit job.
FDR408 NO CONTROL STATEMENTS WERE FOUND -- JOB TERMINATED
Reason: SYSIN data set is empty OR contained only comment statements (“*” in column 1). The
first control statement can also be supplied by the EXEC statement PARM= option.
There are other forms of this message that indicate that statements required for a
certain function were not found.
Action: Correct and resubmit job.
FDR409 LENGTH OF op1 EXCEEDS THE LENGTH OF op2
Reason: The number of significant characters specified for the “op1” operand exceeds the
number of significant characters specified for the “op2” operand. They are interrelated
and “op2” must be as long as or longer than “op1”.
Action: Refer to the documentation in this manual for the program you are executing. Correct
the operands specified and resubmit the control statement.
FDR410 VOL=vvvvvv ASSUMED FOR DSN=dsname
Reason: A command specified DSN= and did not specify VOL=. The data set “dsname” was a
cataloged, single-volume data set. The program assumed that the volume where the
data set was cataloged was the volume on which the user wanted the command to
process the data set.
Action: If the assumption was correct, none. Otherwise, you may wish to reverse the effect of
the command (e.g., by issuing RESET ARCHIVE if the original command was
ARCHIVE) and then to reissue the original command specifying VOL=.
FDR411
Reason:
Action:
MISSING ABRINIT, MAINT, OR SELECT CONTROL STATEMENTS(S) -- JOB TERMINATED
FDRABRM was executed with DEFAULT as the only control statement.
Check your control statement listing, correct any errors found and resubmit the job.
CHAPTER 100 – PAGE 100-81 –