FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
MESSAGES FROM FDR, DSF, AND ABR (FDRNNN) 100.3
Action:
– They were archived by ABR and recataloged for Auto-recall.
NOTE: If you have volumes with VTOCs located above relative track 32767, CATDSN=
thinks that data sets on those volumes are cataloged for recall and does not select
them. INNOVATION DATA PROCESSING recommends that such VTOCs be
relocated lower on the volume; COMPAKTOR can do this.
J INSUFFICENT STORAGE – The REGION size was not large enough.
Increase the REGION (use REGION=0M if you can) and resubmit.
K ABR BACKUP NOT FOUND VOL=vvvvvv – The ABR backup file for a
cloned data set was not found in the ABR catalog. The current backup of a
selected data set is no longer recorded.
Serious errors cause an U0502 ABEND. Others (such as reason “1”) are simply treated as if
a SELECT statement did not select any data sets, unless SELTERR=NO was specified.
FDR346
Reason:
FILTER SELECTED VOL=volser DSN=dsname
FILTER SELECTED ALIAS=alias CAT=catalog TIME=hhmmss
FILTER SELECTED nnnnnnnn ENTRIES in sssss.ss SECONDS
A filter was used to select entries from the system catalogs. The first form of the FDR346
message is displayed only if PCATDSN= is used (instead of CATDSN=) and indicates
each data set name selected from the catalog and the volser it is cataloged on.
The second form of the FDR346 message is displayed only if the PRTALIAS operand is
specified, and indicates each alias that is selected from the master catalog by the filter
and the name of the user catalog that was searched for it (even if no data sets are
selected in that alias).
The third form of the FDR346 message documents the number of entries selected by
the filter, and the elapsed time in seconds required to complete the search.
FDR347 SMS MGMTCLAS ERROR VOL=volser REASON=reason DSN=dsname
Reason: SMSMANAGE=YES was specified, but an error occurred trying to use SMS
management classes for ABR processing. “volser” identifies the volume being
processed (if known) and “dsname” identifies the data set being processed for errors
related to a particular data set. “reason” describes the error:
GETMAIN FAILURE -- MGMTCLAS DISABLED – Indicates that the GETMAIN for
storage above the 16M line to hold the definitions of all active management
classes failed. Management class processing is disabled.
NVR/VVR TYPE UNKNOWN – A VVDS record was not type N, Z, or Q. The VVDS
may be damaged.
TYPE 21 NOT FOUND – The type 21 cell was not found in a VSAM VVR. The
VVDS may be damaged.
TYPE 22 NOT FOUND – The type 22 sub-cell was not found in a non-VSAM NVR.
The VVDS may be damaged.
TYPE 23 NOT FOUND – The type 23 cell was not found in a VSAM VVR. The
VVDS may be damaged.
TYPE 24 NOT FOUND – The type 24 cell was not found in a non-VSAM NVR. The
VVDS may be damaged.
MGMTCLAS INVALID – The management class name in the NVR/VVR of an
SMS-Managed data set (or the default management class name) is not
currently defined to SMS.
NO MGMTCLAS TABLE – Internal error.
NO VVDS ENTRY – No NVR/VVR was found in the VVDS for an SMS-Managed
data set. The VVDS or the VTOC may be damaged, or creation of an
SMS-Managed data set was interrupted.
CHAPTER 100 – PAGE 100-75 –