FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
COMPAKTOR MESSAGES (CPKNNNXX) 100.6
CPK429E INPUT DEVICE ON UNIT=uuuu,VOLSER=vvvvvv IS NOT SUPPORTED BY process
Reason: An unsupported disk device was referenced for COMPAKTOR or TYPE=FASTCPK.
See Section 2.10 “FDR Functions and Features” for a list of supported device types. If
TYPE=FASTCPK is printed, the disk control unit is an old model that does not support
the commands used by Fast Compaktion.
Action: Contact INNOVATION DATA PROCESSING for technical assistance.
CPK430E
Reason:
Action:
THE DEVICE TO RESTORE TO -- devtype1 reason THE INPUT DEVICE -- devtype2
When doing a COMPAKT-from-backup, and the output disk (type “devtype1”) is not the
same as the input disk (“devtype2”) the disks are incompatible devices. “reason” may be:
IS INCOMPATIBLE WITH – The disks are different device types (e.g., 3380 and 3390).
IS SMALLER THAN EAV – The disks are the same type, but the input is an EAV and
the output is not. An EAV volume cannot be restored to a non-EAV volume.
IS SMALLER THAN – The disks are the same type but the output disk is smaller than the
input. This is a warning; as long as all the data fits on the output disk and there are
no unmovable data sets above the end of the output disk, the run is successful.
Retry with a valid device as the target device.
CPK431E ERROR TRYING TO DETERMINE DEVICE TYPE
Reason: A DEVTYPE SVC issued to verify the device type received a non-zero return code.
Action: Contact INNOVATION DATA PROCESSING for technical assistance.
CPK432E ’SIZE=nnnnn’ IS TOO LARGE
Reason: The specified new VTOC size “nnnnn” is excessively large.
Action: Correct the error and rerun.
CPK433E INVALID CCHH POSITION SPECIFIED -- ccccchhhh
Reason: A POS= operand was specified with a track address but
❖ The cylinder address “ccccc” is invalid. It exceeds the device capacity.
❖ The track address “hhhh” is invalid. It exceeds the maximum number of tracks per
cylinder.
❖ The given value is all zeroes.
Action: Correct the invalid address and rerun.
CPK451E INVALID CONTINUATION OF A QUOTED STRING.
Reason: A quoted string was improperly continued onto the following control statement. It does
not start at column 16 of the continuation statement.
Action: Correct the error and rerun.
CPK452E EXPECTED CONTINUATION CARD NOT RECEIVED.
Reason: Continuation was indicated on a control statement, but no further control statements
followed.
Action: Correct the error and rerun.
CPK453E CONTINUATION COLUMN IS NON-BLANK, BUT LAST PARAMETER DOES NOT
END WITH A COMMA OR IN COLUMN 071.
Reason: See rules for “Continuing an Operand Field” in Section 1.2.
Action: Correct the error and rerun.
CPK454E INTERNAL PROGRAM ERROR. CALL VENDOR FOR ASSISTANCE
Reason: Program software error.
Action: Contact INNOVATION DATA PROCESSING for assistance.
CHAPTER 100 – PAGE 100-128 –