FDR V54L78 - Innovation Data Processing

MESSAGES AND CODES
MESSAGES FROM FDR, DSF, AND ABR (FDRNNN) 100.3
FDR412 NO ABRINIT, MAINT, OR SELECT CONTROL STATEMENTS – VTOC UPDATE
PROCESSING NOT REQUIRED
Reason: No ABRINIT, MAINT, or SELECT control statements were read during processing of the SYSIN.
Action:
If the assumption was correct, none. Otherwise, you should add the correct control statements.
FDR413 DSN/DSG type ERROR -- description
Reason: There is an error in the specification of the DSN= or DSG= operand. “description” may be:
Action:
MAX INDEX LEVEL EXCEEDED – A maximum of 22 leading periods are allowed.
NO SIGNIFICANT DATA – The leading periods were followed by a comma or blank.
INVALID CHARACTERS – Invalid characters in the name.
INVALID GENERATION – A GDG generation number was specified, but it is invalid.
MAX INDEX LENGTH EXCEEDED – An index level exceeded 8 characters.
Refer to the documentation in this manual for the program you are executing. Correct
and resubmit.
FDR414 IGNORED -- description -- DSN=dsname
Reason: The device type returned for the data set was not that of a disk device or the data resides on
multiple volumes. The processing requested for this data set is not performed.
Action: Correct and resubmit job.
FDR415
Reason:
Action:
ON VOLSER vvvvvv(uuuu) - DSCB tt-cccchhhhrr-CHAINED TO DSCB tt-cccchhhhrr - action
An invalid DSCB chain was detected in the VTOC of volume “vvvvvv” and the unit
“uuuu” on which the volume resides. Information is displayed for the current DSCB
and the invalid DSCB it chains to. “tt” is the DSCB type (1-7) and “cccchhhhrr” is the
record address (cylinder, track, and record number) of the DSCB. “action” may be:
PROCESSING CONTINUES – If the information in the DSCB is not critical for this
operation.
NOT FOUND IN INCORE VTOC – If the chained DSCB is not found in a copy of the
VTOC saved in storage. The operation is terminated.
NOTE: “uuuu” displays as “0000” when the DATATYPE is TVTOC.
Even though the program may have been able to continue, this is a serious problem.
Determine the data set(s) involved and attempt to correct the DSCB. You can use
COMPAKTOR to help confirm and identify the error. If unable to determine the cause
of the error, contact INNOVATION DATA PROCESSING for assistance.
FDR416 IMPROPER USE OF OPERAND -- description
Reason: An operand was used improperly. “description” identifies the operand and the reason.
Action: Refer to the documentation in this manual for the program you are executing. Eliminate
the bad operand or use it correctly.
FDR417 USE OF RESTRICTED FEATURE -- description
Reason: A feature has been disabled in the FDR Global Options Table. “description” identifies
the feature. Attempts to use a disabled feature results in the sub-command being
marked in error.
Action: Eliminate the restricted feature. Rerun or restart the job.
FDR418 COMMAND PROCESSING DETECTED ERROR--action
Reason: An error was encountered during the processing of a statement. Always proceeded by
one or more messages that define the error. “action” is one of:
RE-ENTER COMMAND OR END – Message for user that has SYSIN data set
assigned to a TSO terminal. Re-enter command in error or “END” to
complete the processing.
SKIPPING FOR COMMAND – Processing continues for all command statements
found within the SYSIN data set.
CHAPTER 100 – PAGE 100-82 –