Expert Documentation

Chapter 12
Type Message Location Additional Information Action
56 ISDN BOARD ACCESS
The ISDN protocol management
module detected a layer 1
problem on a T0 or T2 access
Board location.
Access marker
INFO 0 = access status (0 = access
KO, 1 = access OK)
INFO 1 = type of access (03 = T0,
23 = DLT0)
57 TEI DELETION CPU (80) INFO 0 = D-channel
INFO 1 = TEI
59 R_ANO_VOWLAN_ACCESS.
Voice over WLAN access problems.
70 PRINTER THRESHOLD K.O.
Message emitted by the spooler
when the array where the tickets
are stored is 70% full
71 PRINTER THRESHOLD O.K.
Message emitted by the spooler
when the array where the tickets
are stored is less than 70%
full again
80 R_DHCP_SERVER_EXITED
DHCP server exited due to bad
configuration or option definition
error or IP address not in subnet
or restart failed
81 R_DHCP_SERVER_STATUS
DHCP server status changed
INFO 0 = Code of error:
1 = Rate of calls cut/total calls on
system reached 5%
2 = Saturation time on one AP
reached 1 minute
3 = Saturation number on one AP
reached 3 times
4 = Rate of refused calls/total calls
on system reached 5%
5 = Rate of calls cut/total calls on
one handset reached 5%
6 = Rate of refused calls cut/total
calls on one handset reached 5%
Board location INFO 0 = Bad configuration
INFO 1 = Option definition error
INFO 2 = IP address not in subnet
INFO 3 = Restart failed
Board location INFO 0 = DHCP server normal exit
INFO 1 = DHCP server started successfully
90 ENTERING AN MMC SESSION CPU (80) INFO 0 =1: ADMINISTRATOR
password; 2: INSTALLER password;
3: OPERATOR password; 5:
GUARDED password
91 END OF MMC SESSION CPU (80)
100 BOARD BACK IN SERVICE
(Following a system stoppage
or after being unplugged)
Board location INFO 0 = type of board
Analyze the
reason why
the TEI was
modified by
the network
carrier.
Check the
printer and its
cable connection
12-20