Expert Documentation

Chapter 8
• "Automatic call setup (on reception) on going off-hook" (or restrict the line in order to
exclude outside calls. To call out, the user dials the call number for reception).
• "Count total recall" in automatic mode (or using the manual mode from the Reception
set)
- Configure the Reception set by using the features:
• "Trunk assign" (use, for example, barring table No. 2 which only authorizes internal
calls)
• "Trunk assign with count total recall" (use, for example, table No. 4 which authorizes
national and international calls)
• "Count total recall" in manual mode
- Authorize the feature rights: "trunk assign" and "count total recall"
- Position the flag "count total recall if there is no charge" (see the Count total recall feature
in System Parameters)
Analog room sets
- Assign a "voice mail" virtual key to the analog sets which will light the LED when there is a
callback request from Reception or from the voice mail unit
Barring tables
- Check the link Class of Service on the sets installed
- Check the link Class of Service on the trunk group and network lines
Hotel Parameters
- Configure the parameters: "Wake-up", "DDI", "Language", "Restriction", "DND", "Exit time"
and "Check-in" (see Customizing the configuration screens)
- Configure the Room status parameters (see Configuring room status)
Guest account charging
- Configure the parameters: "Deposit", "Currency" and "VAT" (see Customizing the
configuration screens)
- Configure the parameters: "Room status" print out, Thank-you messages, VAT, Cost of
calls, Surcharge and Cut-off (see the Account charging features in System Parameters)
8.2.2.1.2 SYSTEM PARAMETERS
The following flow chart shows the required system parameters; they are only accessible in the
installer session.
8-8