Expert Documentation

Chapter 3
Switch to block dialing mode -- --
Delete digit preceding the cursor in block
mode dialing (number and sub-address)
F.K.: ISDN or P.K.:
BMdial
F.K.: CLIR
F.K.: ISDN
S.K.: Rubout
Add a sub-address in block dialing mode -- -- P.K.: SubAdd S.K.: SubAdd
To validate the sub-address, in block dialing
mode
Add UUS, in block dialing mode -- -- --
Activation of calling line identification restriction,
in block dialing mode
-- -- P.K.: SubAdd S.K.: OK
S.K.: Text + n° of
message (from 0 to
27) (*)
-- -- -- S.K.: CLIR
To set up the call in block dialing mode (with
or without sub-address, with or without UUS). -- -- F.K.: ISDN or P.K.:
BMdial
S.K.: Send
Activate malicious call identification Feature code S.K.: MCID
(*) Messages 1 to 27 are pre-defined in the system. Some of them have a variable part which
must be completed (return time, room number, etc.). Message No "0" can be made up
completely from the alphabetic keypad (up to 32 characters).
3.41 ISDN Services With Keypad Facility
3.41.1 Overview
3.41.1.1 KEYPAD DIALING FEATURES
In some countries, the public ISDN exchange carriers provide services that can be activated
using the ETSI ETS 300 122 protocol (in addition to these generic services, each public carrier
defines how these services are handled in their national specifications).
To access these services, the system establishes transparent calls between the public
exchange and the internal users, who can then key in codes and receive a response from the
public exchange.
This service is available with all station types on an Alcatel-Lucent OmniPCX Office
Communication Server system directly connected to the public exchange (not through a
private network).
Up to R2.0, the operator services can only be activated from the rest state of the set. From
R2.1, in addition to activation from the rest state, it is possible to activate the services of the
operator during the call (for instance using the "conference operator" service to set up a
conference with 2 outside parties while only using a single B channel)
3.41.2 Configuration procedure
3.41.2.1 Configuration
- To activate the service at system level:
3-112