FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

Common specificationsProtective/warning functionEnvironment*1 Can be displayed only on the operation panel (FR-DU07).*2 Can be displayed only on the parameter unit (FR-PU04/FR-PU07).*3 Temperature applicable for a short period in transit, etc.*4 Only the 75K or more functions.*5 2.9m/s 2 or less for the 185K or more.*6 This protective function does not function in the initial status.Overcurrent during acceleration, overcurrent during constant speed, overcurrent duringdeceleration, overvoltage during acceleration, overvoltage during constant speed, overvoltageduring deceleration, inverter protection thermal operation, motor protection thermal operation,heatsink overheat, instantaneous power failure occurrence, undervoltage, input phase loss *6,motor overload, output side earth (ground) fault overcurrent, output phase loss, externalthermal relay operation *6, PTC thermistor operation *6, option fault, parameter error, PUdisconnection, retry count excess *6, CPU alarm, operation panel power supply short circuit,24VDC power output short circuit, output current detection value excess *6, inrush current limitcircuit alarm, communication alarm (inverter), analog input error, internal circuit error (15Vpower supply), fan fault, overcurrent stall prevention, overvoltage stall prevention, regenerativebrake prealarm electronic thermal relay function prealarm, PU stop, maintenance timer alarm*1*6, brake transistor alarm detection *4, parameter write error, copy operation error, operationpanel lock, parameter copy-10°C to +50°C (non-freezing)90%RH or less (non-condensing)-20°C to +65°CIndoors (without corrosive gas, flammable gas, oil mist, dust and dirt etc.)Maximum 1000m above sea level for standard operation. After that derate by 3% for everyextra 500m up to 2500m (92%) 5.9m/s 2 or less *5SPECIFICATIONSAmbient temperatureAmbient humidityStorage temperature*3AtmosphereAltitude, vibration1217