FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

4ADJUSTMENTParameter listFunctionEnergy saving monitorParameter891 Refer to Pr.52.892 Load factor 0.1% 100% 30 to 150%893894895Energy savingmonitor reference(motor capacity)Control selectionduring commercialpower-supplyoperationPower saving ratereference value0.01/0.1kW*16Inverterratedcapacity1 01 9999896 Power unit cost 0.01 9999897898899RelatedparametersNamePower savingmonitor averagetimePower savingcumulative monitorclearOperation time rate(estimated value)IncrementsInitialValue1 99991 99990.1% 99990.1 to 55/0 to 3600kW*16Set the load factor for commercial powersupplyoperation.This value is used to calculate the powerconsumption estimated value duringcommercial power supply operation.Set the motor capacity (pump capacity).Set when calculating power saving rateand average power saving rate value.*16 The setting depends on the invertercapacity (55K or less/75k or more)0 Discharge damper control (fan)1 Inlet damper control (fan)2 Valve control (pump)3Commercial power-supply drive (fixedvalue)Consider the value during commercial0power-supply operation as 100%1 Consider the Pr.893 setting as 100%.9999 No function◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦0 to 500Set the power unit cost. Display the powersaving rate on the energy saving monitor ◦ ◦ ◦9999 No function0 Average for 30 minutes1 to 1000h Average for the set time9999 No function0 Cumulative monitor value clear1 Cumulative monitor value hold10Range9999DescriptionCumulative monitor continue(communication data upper limit 9999)Cumulative monitor continue(communication data upper limit 65535)Use for calculation of annual power0 to 100% saving amount. Set the annual operationratio (consider 365 days × 24hr as 100%).9999 No functionParametercopyParameterclearAllparameterclear◦: enabled× : disabled◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦Parameter list89