FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

Make a start and stop with terminals(external operation)Operation7. Mode/monitor checkPress twice to choose themonitor/frequency monitor.8. Turn on the high speed switch (RH).ONHigh speedMiddle speedLow speedDisplay9. Turn the start switch (STF or STR) on." " (50Hz) appears.• 30Hz appears when RM is on and 10Hzappears when RL is on.ONForward rotationReverse rotation10. StopTurn the start switch (STF or STR) off.The motor stops according to Pr. 8Deceleration time.ForwardrotationOFFReverserotationStop[EXT] is not lit even whenis pressed ... Why?Switchover of the operation mode withis valid when Pr. 79 = "0" (initial value).60Hz, 30Hz and 10Hz are not output from RH, RM and RL respectively when they are turned on. ... Why?Check for the setting of Pr. 4, Pr. 5, and Pr. 6 once again.Check for the setting of Pr. 1 Maximum frequency and Pr. 2 Minimum frequency once again. (Refer topage 57)Check for the Pr. 79 setting once again. (Pr. 79 must be set to "0" or "2".) (Refer to page 61)Check that Pr. 180 RL terminal function selection = "0", Pr. 181 RM terminal function selection = "1",Pr. 182 RH terminal function selection = "2" and Pr. 59 Remote function selection = "0". (all are initialvalues)[FWD (or REV)] is not lit. ... Why?Check that wiring is correct. Check it again.Check that "60" is set in Pr. 178 STF terminal function selection (or "61" is set in Pr. 179 STR terminalfunction selection)?(all are initial values)How is the frequency setting from 4 to 7 speed ?The setting differs according to Pr. 24 to Pr. 27 (multi-speed setting). Refer to Instruction Manual(applied) chapter 4.Perform multi-speed operation higher than 8 speed. ... How?Use the REX signal to perform the operation. Refer to Instruction Manual (applied) chapter 4.REMARKS· External operation is fixed by setting "2" (external operation mode) in Pr. 79 Operation mode selection when you do not want to taketime pressing or when you want to use the current start command and frequency command. (Refer to page 61)50