FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

For customers who have replaced the older model with this inverterAPPENDICESAppendix 1 For customers who have replaced the older model with thisinverterAppendix 1-1(1) Instructions for installationReplacement of the FR-F500 series1)Removal procedure of the front cover was changed. (with screws) Please note. (Refer to page 5.)2)Removal procedure of the operation panel was changed. (with screws) Please note. (Refer to page 5.)3)Plug-in options of the F500 series are not compatible4)Operation panel (FR-DU04) can not be used.5)Setup software (FR-SW0-SETUP) can not be used.(2) Wiring instructions1)The control circuit terminal block can be used for the FR-F700 series without removing wiring.Note that the wiring cover (0.75K to 30K) is not compatible.FR-F500 seriesFR-F700 series(Note that the relay output 2 (A2, B2, C2) specific for the FR-F700 series can not be used with the FR-F500 seriesterminals.)(3) Instructions for continuous use of the FR-PU04 (parameter unit)1)For the FR-F700 series, many functions (parameters) have been added. When setting these parameters, theparameter name and setting range are not displayed. Parameter list, change list, initial value list, initial value list2 and parameter clear of the HELP function can not be used.2)For the FR-F700 series, many protective functions have been added. These functions activate, but all faults aredisplayed as "Fault 14". When the faults history has been checked, "E.14" appears. Added faults display will notappear on the parameter unit.3) User initial value setting can not be used.4) User registration/clear (user group 2) can not be used.5) Parameter copy/verification function can not be used.136