12.07.2015 Views

FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

4ADJUSTMENTParameter listFunctionPU connector communicationParameter117118119120121122123124Relatedparameters342551NamePU communicationstation numberPU communicationspeedPU communicationstop bit lengthPU communicationparity checkNumber of PUcommunicationretriesPU communicationcheck time intervalPU communicationwaiting time settingPU communicationCR/LF selectionCommunicationEEPROM writeselectionPU mode operationcommand sourceselectionIncrementsInitialValue1 0 0 to 311 1921 11 21 10.1s 99991 99991 11 01 248, 96, 192,384Specify the inverter station number.Set the inverter station numbers when two ormore inverters are connected to one personalcomputer.Set the communication speed.The setting value × 100 equals thecommunication speed.For example, the communication speed is19200bps when the setting value is "192".<strong>Stop</strong> bit length data length0 1bit 8bit1 2bit 8bit10 1bit 7bit11 2bit 7bit0 Without parity check1 With odd parity check2 With even parity check0 to 109999Set the permissible number of retries atoccurrence of a data receive error.If the number of consecutive errorsexceeds the permissible value, theinverter will come to trip.If a communication error occurs, theinverter will not come to trip.0 No PU connector communicationSet the communication check time interval.If a no-communication state persists for0.1 to 999.8slonger than the permissible time, theinverter will come to trip.9999 No communication check◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦Set the waiting time between data0 to 150mstransmission to the inverter and response. ◦ ◦ ◦9999 Set with communication data.0 Without CR/LF1 With CR2 With CR/LF0112RangeDescription◦ ◦ ◦Parameter values written bycommunication are written to the EEPROMand RAM. ◦ ◦ ◦Parameter values written bycommunication are written to the RAM.Select the RS-485 terminals as the PUoperation mode control source.Select the PU connector as the PUoperation mode control source.ParametercopyParameterclearAllparameterclear◦: enabled× : disabled◦ ◦ ◦Parameter list77

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!