FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

4ADJUSTMENT4.8 Parameter copy and parameter verificationParameter copy and parameter verificationPCPY SettingDescription0 Cancel1 Copy the source parameters to the operation panel.2 Write the parameters copied to the operation panel into the destination inverter.3 Verify parameters in the inverter and operation panel. (Refer to page 64.)REMARKS· When the copy destination inverter is not the FR-F700 series or parameter copy write is performed after parameter copy read isstopped, “model error ( )” is displayed.· Refer to the parameter list on page 68 and later for availability of parameter copy.· When the power is turned off or an operation panel is disconnected, etc. during parameter copy write, perform write again or check thevalues by parameter verification.4.8.1 Parameter copyParameter settings can be copied to multiple inverters.OperationDisplay1.Connect the operation panel to thecopy source inverter.• Connect it during a stop.2.Press to choose the parametersetting mode.The parameternumber previouslyread appears.3.Turn until (parameter copy)appears.4.Press to to read the currently set value." "(initial value) appears.5.Turn to change it tothe setting value " ".6.Press to copy the source parametersto the operation panel.About 30s laterThe frequency flickersfor about 30sFlicker ··· Parameter copy complete!!7.Connect the operation panel to thecopy source inverter.8.After performing steps 2 to 5,turn to change it to " ".9.Press to write the parameters copied tothe operation panel to the destination inverter.The frequency flickersfor about 30s10.When copy is completed," " and " " flicker.11.After writing the parameter values to the copydestination inverter, always reset the inverter,e.g. switch power off once, before starting operation.Flicker ··· Parameter copy complete!!63