FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

4ADJUSTMENTParameter listFunctionTerminal assignment of output terminal—Increase coolingfan lifeParameter190191192193194RUN terminalfunction selectionSU terminalfunction selectionIPF terminalfunction selectionOL terminal functionselectionFU terminal functionselection195 ABC1 terminalfunction selection196ABC2 terminalfunction selection232 to 239 Refer to Pr.4 to Pr.6.240 Refer to Pr.72.241 Refer to Pr.125 and Pr.126.242, 243 Refer to Pr.73.244RelatedparametersNameCooling fanoperation selectionIncrementsInitialValue1 00 to 5, 7, 8,10 to 19, 25,26, 45 to 47,64, 70,0, 100: Inverter running1, 101: Up to frequency2, 102: Instantaneous power failure/undervoltage3, 103: Overload warning4, 104: Output frequency detection5, 105: Second output frequency◦ × ◦1 1 ◦ × ◦90 to 96, 98, detection99, 7, 107: Regenerative brake prealarm100 to 105, (Only for the 75K or more)107, 108, 8, 108: Electronic thermal relay function1 2 110 to 116, prealarm◦ × ◦125, 126, 10, 110: PU operation mode145 to 147, 11, 111: Inverter operation ready164, 170, 12, 112: Output current detection190 to 196, 13, 113: Zero current detection1 3 198, 199,◦ × ◦14, 114: PID lower limit9999 15, 115: PID upper limit1 416, 116: PID forward/reverse rotationoutput◦ × ◦17, —: Bypass operation switchoverMC118, —: Bypass operation switchoverMC219, —: Bypass operation switchover1 99MC325, 125: Fan fault output◦ × ◦0 to 5, 7, 8,10 to 19, 25,26, 45 to 47,64, 70, 90,91, 94 to 96,98, 99,100 to 105,107, 108,110 to 116,125, 126,145 to 147,164, 170,26, 126: Heatsink overheat pre-alarm45, 145: Inverter running and startcommand is on46, 146: During deceleration atoccurrence of power failure(retained until release)47, 147: During PID control activated64, 164: During retry70, 170: PID output interruption90, 190: Life alarm91, 191: Fault output 3 (power-off signal)92, 192: Energy saving average value1 9999190, 191,updated timing194 to 196, 93, 193: Current average monitor signal◦ × ◦198, 199,999994, 194: Fault output 295, 195: Maintenance timer signal96, 196: Remote output98, 198: Alarm output99, 199: Fault output9999:No function0 to 99: Positive logic, 100 to 199:Negative logic1 101RangeDescriptionOperates at power onCooling fan on/off control invalid (Thecooling fan is always on at power on)Cooling fan on/off control validThe fan is normally on during inverteroperation. The fan switches on/offaccording to the temperature during astop of the inverter whose status ismonitored.ParametercopyParameterclearAllparameterclear◦: enabled× : disabled◦ ◦ ◦Parameter list83