FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

Parameter copy and parameter verificationappears...Why? Parameter read error. Perform operation from step 3 again.appears...Why? Parameter write error. Perform operation from step 8 again.and flicker alternatelyAppears when parameters are copied between the inverter of 55K or less and 75K or more.1. Set "0" in Pr. 160 User group read selection.2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.55K or less75K or morePr. 989 Setting 10 1003. Reset Pr. 9, Pr. 30, Pr. 51, Pr. 52, Pr. 54, Pr. 56, Pr. 57, Pr. 70, Pr. 72, Pr. 80, Pr. 90, Pr. 158, Pr. 190 to Pr. 196, Pr. 557,Pr. 893.4.8.2 Parameter verificationWhether same parameter values are set in other inverters or not can be checked.Operation1.Replace the operation panel on theinverter to be verified.• Replace it during a stop.Display2.Screen at powering onThe monitor display appears.3.Press to choose the parametersetting mode.The parameternumber readpreviously appears.4.Turn until (parameter copy)appears.5.Press to read the currently setvalue." "(initial value) appears.6.Turn to change it to the set value" "(parameter copy verification mode).7.Press to read the parameter settingof the verified inverter to the operation panel.The frequency flickersfor about 30s• If different parameters exist, differentparameter numbers and flicker.• Hold downto verify.Flickering8.It there is no difference,flicker to complete verification.andFlicker ··· Parameter verification complete!!REMARKSWhen the copy destination inverter is not the FR-F700 series, "model error ()" is displayed.flickers ... Why?Set frequencies, etc. may be different. Check set frequencies.64