FR-F700 INSTRUCTION MANUAL (BASIC) - MRO Stop

4ADJUSTMENTParameter listFunction— 340 Refer to Pr.79.Remote outputfunction(REM signal)Maintenance of parts—Current average valuemonitor signal495496497Remote outputselectionRemote output data1Remote output data21 0503 Maintenance timer 1 0 0 (1 to 9998)504Maintenance timeralarm output settime011011Remote output dataclear at powering offRemote output dataretention even atpowering offRemote output dataclear at powering offRemote output dataretention even atpowering offRemote outputdata clear atinverter resetRemote outputdata retention evenat inverter reset◦ ◦ ◦1 0 0 to 4095× × ×Output terminal can be switched on and off.1 0 0 to 4095 × × ×1 99990 to 99989999 No function539,Refer to Pr.331 to Pr.339, Pr.341 to Pr.343.549, 550551 Refer to Pr.117 to Pr.124, Pr.331 to Pr.339, Pr.341 to Pr.343.555556557Current averagetimeData output masktimeCurrent averagevalue monitor signaloutput referencecurrent— 563, 564 Refer to Pr.52.——ParameterRelatedparametersNameIncrements0.1s 1s 0.1 to 1.0s0.1s 0s 0.0 to 20.0s0.01/0.1A*15571 Refer to Pr.13.575 to 577 Refer to Pr.127 to Pr.134.611 Refer to Pr.57 and Pr.58.867 Refer to Pr.54 to Pr.56.872 Refer to Pr.251.InitialValueRatedinvertercurrentRange0 to 500/0 to 3600A*15DescriptionDisplay the cumulative energization timeof the inverter in 100h increments.Reading onlyWriting the setting of "0" clears thecumulative energization time.× × ×Set the time taken until when the maintenancetimer alarm output signal (Y95) is output. ◦ × ◦Set the time taken to average the currentduring start bit output (1s).Set the time for not obtaining (mask)transient state data.Set the reference (100%) for outputtingthe signal of the current average value.*15 Setting increments and setting rangediffer according to the inverter capacity.(55K or less/75K or more)ParametercopyParameterclearAllparameterclear◦: enabled× : disabled◦ ◦ ◦◦ ◦ ◦◦ ◦ ◦Parameter list87