Vol 2 - Garney Construction

1.04 QUALIFICATIONSA. WPSs: In accordance with AWS D1.1/D1.1M (Annex N Forms)] for shop orfield welding; or ASME BPVC SEC IX (Forms QW-482 and QW-483) forshop welding only.B. WPQs: In accordance with AWS D1.1/D1.1M (Annex N Forms);or ASME BPVC SEC IX (Form QW-484).C. CWI: Certified in accordance with AWS QC1, and having prior experiencewith specified welding codes. Alternate welding inspector qualificationsrequire approval by Engineer.D. Testing Agency: Personnel performing tests shall be NDT Level II certified inaccordance with ASNT SNT-TC-1A.1.05 SEQUENCING AND SCHEDULINGA. Unless otherwise specified, Submittals required in this section shall besubmitted and approved prior to commencement of welding operations.PART 2PRODUCTS2.01 SOURCE QUALITY CONTROLA. CWI shall be present whenever shop welding is performed. CWI shallperform inspection, as necessary, prior to assembly, during assembly, duringwelding, and after welding. CWI shall perform inspections as required inAWS D1.1/D1.1M or referenced welding code and as follows:1. Verifying conformance of specified job material and proper storage.2. Monitoring conformance with approved WPS.3. Monitoring conformance of WPQ.4. Inspecting weld joint fit-up and performing in-process inspection.5. Providing 100 percent visual inspection of welds.6. Supervising nondestructive testing personnel and evaluating test results.7. Maintaining records and preparing report confirming results ofinspection and testing comply with the Work.PART 3EXECUTION3.01 GENERALA. Welding and Fabrication by Welding: Conform to governing welding codesreferenced in attached Welding and Nondestructive Testing Table.PW/WBG/382059WELDINGAUGUST 15, 2012 05 05 23 - 3©COPYRIGHT 2012 CH2M HILL