Volvo Maintenance Hints for 7xx/9xx - Bill Garland's Nuclear ...

(c) Replace the emergency brake well (do not replace the screws), aligning it with the
front of the center console
(d) Re-seat the center console, aligning the holes in the bottom of the storage bin, with
the holes in the bracket, to which it is screwed.
(e) Replace the screws in the bottom of the storage bit, but do not tighten fully
(f) Replace the screws in the bottom of the emergency brake well, but do not tighten
fully
(g) Align the center console (do not tighten the screws).
Seat Installation
Preparation
(a) Tighten the plastic wire tires, loosened to allow running ground and positive wire
from the fuse block/emergency brake switch positions, to the front door-side corner of
the seat location
(b) Replace the carpet. Push the edges under the side of the center panel kick panel
and the emergency brake console. Lay the carpet flat from the edge of the emergency
brake console to the door.
(c) Tighten all four screws that secure the center console
(d) Replace the panel in the bottom of the center console storage bin
(e) Replace the ashtray
Seat Installation
(a) Place the powered seat into the car. Put the stud into the key hole in the floor pan
and align the holes in the seat tracks with the bolt holes in the floor pan.
(b) Insert the bolts into the holes, but do not tighten then.
(c) Insert the seat wiring harness connector into the power connector attached to the
front right corner of the power seat.