Volvo Maintenance Hints for 7xx/9xx - Bill Garland's Nuclear ...

one half ofthe headliner material back from edge to glued midline, spray
adhesive on half the backer board and the folded back part of the headliner.
You may want to place clean paper around the headliner edge between the two
layers before spraying adhesive so it doesnt get on the other half of the
headliner which is facing up. Then, roll the headliner back onto the backer
board starting at the midline. Slow and steady, light pressure with your hands,
and it should lay down flat and smooth. Then repeat for the other half.
●
Figure H
Figure I
● With the headliner fabric in place and properly
contoured, you can flip the headliner board over
(figure J) to trim the excess fabric from the edges.
● Start by cutting around the outside, leaving an inch
or so of overlap. For the sunroof opening - cutout
leaving 6" fabric to secure to the roof opening in the
sunroof frame. (figure K).
Figure F
Figure G
Figure J