Agilent 34980A Multifunction Switch/Measure Unit *34980-90005*
Agilent 34980A Multifunction Switch/Measure Unit *34980-90005*
Agilent 34980A Multifunction Switch/Measure Unit *34980-90005*
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3 Features and Functions<br />
Non-Sequential Scanning<br />
By default, the instrument scans the list of channels in ascending order<br />
from slot 1 through slot 8 (channels are reordered as needed). If your<br />
application requires non- ordered scanning of the channels in the present<br />
scan list, you can use the non- sequential scanning mode.<br />
This feature is available from the remote interface only.<br />
The scanning mode applies to the entire mainframe and cannot be<br />
selectively used on individual modules.<br />
When sequential scanning is enabled (default), the channels in the scan<br />
list are placed in ascending order from slot 1 through slot 8. Duplicate<br />
channels are not allowed. For example, (@2001,1003,1001,1003) will be<br />
interpreted as (@1001,1003,2001).<br />
When sequential scanning is disabled (OFF), the channels remain in the<br />
order presented in the scan list (see exception below). Multiple<br />
occurrences of the same channel are allowed. For example,<br />
(@2001,2001,2001) and (@3010,1003,1001,1005) are valid and the<br />
channels will be scanned in the order presented.<br />
When you specify a range of channels in the scan list, the channels are<br />
always sorted in ascending order, regardless of the scan order setting.<br />
Therefore, (@1009:1001) will always be interpreted as 1001, 1002, <br />
1003, etc.<br />
If you define a scan list with the sequential mode enabled and later<br />
disable the mode, the scan list will not be reordered; however, the scan<br />
list will be treated as a non- sequential list thereafter.<br />
If you have defined a scan list with the sequential mode disabled (OFF)<br />
and later enable the mode, the channels will be reordered.<br />
Non- sequential scan lists are not stored as part of the instrument state<br />
by the *SAV command; in this case, the ordered mode will be enabled<br />
and the scan list will be empty when the instrument state is restored<br />
(*RCL command).<br />
The scan order setting is stored in volatile memory and the ordered<br />
mode will be enabled when power is turned off or after a Factory Reset<br />
(*RST command).<br />
Remote Interface Operation: ROUTe:SCAN:ORDered {OFF|ON}<br />
124 <strong>Agilent</strong> <strong>34980A</strong> Mainframe User’s Guide