Agilent 34980A Multifunction Switch/Measure Unit *34980-90005*
Agilent 34980A Multifunction Switch/Measure Unit *34980-90005*
Agilent 34980A Multifunction Switch/Measure Unit *34980-90005*
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3 Features and Functions<br />
You can display a message on the front panel by sending a command<br />
from the remote interface. The instrument can display up to 18<br />
characters on the upper line of the front- panel display; any additional<br />
characters are truncated (no error is generated). You can use letters<br />
(A- Z), numbers (0- 9), and special characters like “@”, “%”, “*”, etc. <br />
Use the “#” character to display a degree symbol ( ° ). Commas, periods,<br />
and semicolons share a display space with the preceding character, and<br />
are not considered individual characters.<br />
While a message is displayed on the front panel, readings from a scan<br />
or monitor are not sent to the front- panel display.<br />
Sending a text message to the display overrides the display state; <br />
this means that you can display a message even if the display is<br />
turned off. In addition, pressing any front- panel key will clear the <br />
text message.<br />
Remote Interface Operation: The following command turns off the<br />
front- panel display.<br />
DISPLAY OFF<br />
The following command displays a message on the front panel and turns<br />
on the display if currently disabled (the quotes are not displayed).<br />
DISPLAY:TEXT "SCANNING ..."<br />
To clear the message displayed on the front panel (without changing the<br />
display state), send the following command.<br />
DISPLAY:TEXT:CLEAR<br />
Front-Panel Number Format<br />
The instrument can show numbers on the front- panel display with periods<br />
or commas for the decimal point (radix) and thousands separator.<br />
This feature is available from the front panel only.<br />
The number format is stored in non- volatile memory, and does not<br />
change when power has been off, after a Factory Reset (*RST<br />
command), or after an Instrument Preset (SYSTem:PRESet command).<br />
When shipped from the factory, a period is used as the radix character<br />
and commas are used for the digits separator (e.g., +1.234,56 VDC).<br />
Front Panel Operation: Utility > MISC. SETTINGS > RADIX|THOUSAND SEPARATOR<br />
152 <strong>Agilent</strong> <strong>34980A</strong> Mainframe User’s Guide