ABBREVIATIONS USED IN THIS MANUAL

AT8299
AT8300
AT8291
AUTOMATIC TRANSAXLE (A241H) - Component Parts (Valve Body)
(b) Install the transaxle housing to the transaxle case.
Torque: 29 N-m (300 kgf-cm, 22 ft-lbf)
(c) Turn the differential assembly counterclockwise
and clockwise several time.
(d) Using a spring tension gauge, measure the differential
side bearing preload.
Preload (at starting):
New bearing 245 - 43.1 N
(2.5 - 4.4 kg, 5.5 - 9.7 lb)
Reused bearing 12.7 - 21.6 N
(1.3 - 2.2 kg, 2.9 - 4.9 lb)
If the preload is not within specification, select the
thrust washer.
Mark Thickness mm (in.) Mark Thickness mm (in.) Mark Thickness mm (in.)
51 2.00 (0.0787) J 2.24 (0.0882) 61 2.50 (0.0984)
B 2.03 (0.0799) K 2.27 (0.0894) 62 2.55 (0.1004)
C 2.06 (0.0811) 57 2.30 (0.0906) 63 2.60 (0.1024)
D 2.09 (0.0823) M 2.33 (0.0917) 64 2.65 (0.1043)
E 2.12 (0.0835) N 2.36 (0.0929) 65 2.70 (0.1063)
54 2.15 (0.0846) P 2.39 (0.0941) 66 2.75 (0.1083)
G 2.18 (0.0858) Q 2.42 (0.0953) 67 2.80 (0.1102)
H 2.21 (0.0870) 60 2.45 (0.0965) 68 2.85 (0.1122)
AX-199
(e) Remove the differential assembly from the transaxle
case.
13. INSTALL DIFFERENTIAL OIL SEAL RINGS
Install the two oil seal rings to the ring gear mounting
case lower side grooves.