ABBREVIATIONS USED IN THIS MANUAL

AX-156
AT3111
AT2863
AT3141
AT2865
AT2866
AUTOMATIC TRANSAXLE (A241H) - Removal of Component Parts
SST
(c) Remove the C1 piston and two springs.
(d) Using low-pressure compressed air (98 kPa, 1
kg/cm 2 , 14 psi), pop out the C2 piston into a rag.
Force air into the hole shown and remove the
piston and spring.
(e) Using low-pressure compressed air (98 kPa, 1
kg/cm 2 , 14 psi), pop out the B2 piston into a rag.
Force air into the hole shown and remove the piston
and spring.
21. MEASURE PISTON STROKE OF SECOND COAST
BRAKE
(a) Apply a small amount of paint to the piston rod at
the point it meets the case as shown in the illustration.
(b) Using SST, measure the piston stroke applying
and releasing the compressed air (392 - 785 kPa,
4 - 8 kg/cm 2 , 57 - 114 psi) as shown.
SST 09240-00020
Piston stroke: 1.5 - 3.0 mm (0.059 - 0.118 in.)
If the piston stroke exceed the limit, inspect the brake
band.