25.07.2013 Views

ABBREVIATIONS USED IN THIS MANUAL

ABBREVIATIONS USED IN THIS MANUAL

ABBREVIATIONS USED IN THIS MANUAL

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

AT0643<br />

AT3114<br />

AT0108<br />

AT0645<br />

AT3433<br />

AUTOMATIC TRANSAXLE (A241H) - Installation of Component Parts<br />

Clamp<br />

73. <strong>IN</strong>STALL THROTTLE CABLE <strong>IN</strong> CASE<br />

Push the cable through the hole on the case, being<br />

careful not to damage the O-ring. Check for full seating.<br />

NOTICE: In subsequent work, to avoid breaking the<br />

cable fitting do not roll the case over the cable.<br />

74. <strong>IN</strong>STALL O/D SOLENOID WIRE<br />

AX-225<br />

75. <strong>IN</strong>STALL VALVE BODY<br />

(a) Pace the valve body on the transmission.<br />

(b) While holding the cam down with your hand, slip<br />

the cable end into the slot.<br />

(c) Connect the connecting rod to the manual valve<br />

lever.<br />

(d) lower the valve body in place.<br />

(e) Install the twelve bolts and wire retainer shown in<br />

the illustration, and hand tighten all the bolts first.<br />

Then tighten them with a torque wrench.<br />

H<strong>IN</strong>T: Each bolt length (mm) is indicated in the illustration.<br />

Torque: 10 N-m (100 kgf-cm, 7 ft-lbf)

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!