ABBREVIATIONS USED IN THIS MANUAL

AT7987
AT8072
AT7999
AT1293
AT1294
AUTOMATIC TRANSAXLE (A241H) - Installation of Component Parts
17.3 - 18.2 mm
SST
AX-209
22. CHECK HEIGHT OF CLUTCH ASSEMBLY
Using vernier calipers, check the height from the sleeve
to the inner race.
Height: 17.3 - 18.2 mm (0.6811 - 0.7165 in.)
23. CHECK PISTON STROKE OF UNDERDRIVE CLUTCH
(a) Set a dial indicator (long type pick or SST) as
shown.
SST 09350-32014 (09351-32190)
(b) Applying and releasing the compressed air (392 -
785 kPa, 4 - 8 kg/cm 2 , 57 - 114 psi), measure
the underdrive clutch piston stroke.
Piston stroke: 1.50 - 1.86 mm (0.0591 - 0.0732 in.)
If the piston stroke is less than limit, parts may have
been misassembled. Check them.
If the piston stroke is nonstandard, select another
flange.
HINT: There are two different flange thickness.
Flange thickness: 2.04 mm (0.0803 in.)
2.40 mm (0.0945 in.)
24. INSTALL BEARING WITH RACE
Install the thrust bearing with race, with the bearing facing
upward.
Bearing: Outer diameter 43.7 mm (1.720 in.)
Inner diameter 31.0 mm (1.220 in.)
25. INSTALL SUN GEAR To CASE
Install the sun gear of the counter shaft to the case.