ABBREVIATIONS USED IN THIS MANUAL

TR-34
AT3361
AT3360
AT3308
AT3358
AT3359
SST
TRANSFER (A241H) - Component Parts (Transfer Left Case)
SST
4. ADJUST TOTAL PRELOAD
(a) Install the transfer right case.
HINT: Do not apply seal packing and do not install
gasket.
Torque: 44 N-m (450 kgf-cm, 33 ft-lbf)
(b) Using SST and a spring tension gage, measure
the total preload.
SST 09326-2001 1
Preload (at starting):
New bearing
Add driven pinion preload
12.7 - 13.7 N (1.3 - 1.4 kg, 2.9 - 3.1 lb)
Reused bearing
Add driven pinion preload
4.9 - 8.8 N (0.5 - 0.9 kg, 1.1 - 2.0 lb)
(c) Adjusting total preload by tightening the adjusting
nut with SST.
SST 09318-12010
HINT: Measure the preload while tightening the bearing
adjusting nut a little at a time.
5. CHECK RING GEAR BACKLASH
(a) Using a dial indicator, measure the ring gear
backlash.
Backlash: 0.13 - 0.18 mm (0.0051 - 0.0071 in.)
(b) When the backlash is outside the standard value,
select a different plate washer to the one selected
step 3. Again adjust the backlash and total
preload.
6. CHECK TOOTH CONTACT
(a) Coat 3 or 4 teeth at different position on the ring
gear with red lead.
(b) Rotate the ring gear, inspect the teeth pattern.