ABBREVIATIONS USED IN THIS MANUAL

AX-184
AT3409
AT3407
No. 1
Gasket
No. 2
Gasket
AT3497
No. 1 Gasket
AT3496
AT7983
AUTOMATIC TRANSAXLE (A241H) - Component Parts (Valve Body)
Plate
(Assembly of Valve Body)
1. CHECK INSTALLATION OF KEYS, PINS, CHECK
BALLS, STOPPER AND STRAINER
(a) Make sure that the keys and strainer on the upper
side of the lower valve body are installed correctly.
(See page AX-182 )
(b) Make sure that the keys, pins, check balls and
vibrating stopper on the lower side of the upper
valve body and No. 2 pressure regulator valve
body are installed correctly. (See page AX-180 )
2. POSITION PLATE AND NEW GASKETS ON LOWER
VALVE BODY
Position the new No. 2 gasket, plate and then the new
No. 1 gasket on the lower valve body.
HINT: Since the No. 1 gasket and No. 2 gasket are
similar use the illustration below to discriminate between
them.
No. 2 Gasket
AT3495
3. PLACE LOWER VALVE BODY WITH PLATE AND
GASKETS ON UPPER VALVE BODY