ABBREVIATIONS USED IN THIS MANUAL

AX-134
AT2968
AT2023
AT2969
AT0635
AT2970
AUTOMATIC TRANSAXLE (A240L, A241E, A243L) - Installation of Component Parts
Front Race
Rear Race
(b) Install the ring gear.
HINT: If the planetary ring gear and the other parts are
installed correctly into the case, the end of the bushing
with the ring gear flange will be flush with a shoulder of
the intermediate shaft or under.
(c) Coat the races and bearing with petroleum jelly and
install them onto the tip of ring gear flange as shown.
Bearing and races: mm (in.)
Outer diameter Inner diameter
Front Race 37.9 (1.492) 22.0 (0.866)
Bearing 36.1 (1.421) 22.2 (0.874)
Rear Race 35.7 (1.406) 23.0 (0.906)
60. INSTALL SECOND COAST BRAKE BAND
(a) Place the band into the case.
(b) Install the pin through the oil pump mounting bolt
hole.
61. INSTALL FORWARD CLUTCH AND DIRECT CLUTCH
(a) Coat the race and bearing with petroleum jelly,
and install them onto the forward clutch drum.
Bearing and race:
mm (in.)
Outer diameter Inner diameter
Bearing 42.0 (1.654) 28.9 (1.138)
Race 42.0 (1.654) 27.1 (1.067)