ABBREVIATIONS USED IN THIS MANUAL

TR-4
AT3354
AT3360
AT3364
AT3362
AT3361
TRANSFER (A241H) - Removal of Component Parts
SST
4. REMOVE TRANSFER INSPECTION HOLE COVER
Remove the three bolts and inspection hole cover.
5. CHECK PRELOAD
(a) Using SST and a spring tension gauge, measure
the driven pinion preload of the backlash between
the driven pinion and ring gear.
SST 09326-2001 1
Driven pinion preload (at starting):
8.8 - 13.7 N (0.9 - 1.4 kg, 2.0 - 3.1 Ib)
(b) Using SST and a spring tension gauge, measure
the total preload.
SST 09326-201 1
Total preload (at starting):
Add driven pinion preload
4.9 - 8.8 N (0.5 - 0.9 kg, 1.1 - 2.0 Ib)
6. CHECK RING GEAR BACKLASH
Using a dial indicator, measure the ring gear backlash.
Backlash: 0.13 - 0.18 mm (0.0051 - 0.0071 in.)
7. CHECK TOOTH CONTACT
(See pages TR-34 , TR-35 )
8. REMOVE DRIVEN PINION BEARING CAGE
(a) Remove the six bolts.
(b) Using a plastic hammer, remove the bearing
cage.
(c) Remove the O-ring and the shims from the bearing
cage.
9. REMOVE TRANSFER RIGHT CASE
Remove the ten bolts and right case.