ABBREVIATIONS USED IN THIS MANUAL

AX-78
AT0568
AT2932
AT7998
AT4585
AT2933
SST
SST
AUTOMATIC TRANSAXLE - Component Parts (Counter Shaft)
9. REMOVE BEARING
Using SST and press, remove the bearing.
SST 09950-00020
10. REMOVE BEARING OUTER RACES
Using a brass bar and hammer, tap out both bearing
outer races.
INSPECTION OF COUNTER SHAFT
COMPONENTS
1. MEASURE PLANETARY SUN GEAR BUSHING INSIDE
DIAMETER
Using a caliper gauge, measure the bushing inside diameter
of the planetary sun gear as shown.
Standard inside diameter: 29.800 - 29.825 mm
(1.17322 - 1.17421 in.)
Maximum inside diameter: 29.870 mm (1.17598 in.)
2. MEASURE PLANETARY PINION GEAR THRUST
CLEARANCE
Using a feeler gauge, measure the planetary pinion
gear thrust clearance.
Standard clearance: 0.2 - 0.5 mm
(0.008 - 0.020 in.)
Maximum clearance: 0.5 mm (0.020 in.)
If the clearance is greater than the maximum, replace
the planetary gear assembly.
ASSEMBLY OF COUNTER SHAFT
1. INSTALL BEARING TO COUNTER SHAFT
Using SST and press, press in the bearing of the thick
inner race side.
SST 09350-32014 (09351-32180)
2. INSTALL RING GEAR
(a) Install the ring gear to the counter shaft.